Page 1
ECAM45.76X COFFEE MAKER Instructions for use. Keep these instructions Visit www.delonghiregistration.com to register your product Visit www.delonghi.com for a list of service centers near you. ELECTRIC CHARACTERISTICS 120 V~ 60 Hz 1250 W MACHINE À CAFÉ Mode d’ e mploi . Conservez cette notice Visitez www.delonghiregistration.com pour...
CONTENTS 9. MAKING CAPPUCCINOS AND MILK BASED COFFEES ..........14 1. IMPORTANT SAFEGUARDS ......7 9.1 Filling and attaching the milk container ..14 1.1 Short cord instructions .........7 9.2 Adjusting the amount of froth .....14 2. INTRODUCTION ..........8 9.3 Making cappuccinos and milk-based co ees 2.1 Symbols used in these instructions ....8 automatically ..........14 2.2 Letters in brackets .........8...
1. IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed, including the following. • Read all instructions carefully. • Make sure the voltage of your electrical system corresponds to the voltage shown on the bottom of the machine.
B12. OK button: to enable and confirm the selected function 2.4 Video instruction manual available on: B13. Display: guides the user in using the appliance B14. MENU/ESC button to enter the menu (When in the settings http://ecam45760.delonghi.com menu, press to exit the menu) B15. button: to select coffee quantity...
3.3 Description of the accessories If the power socket does not match the plug on the appliance, have the socket replaced with a suitable type by a qualified (page 2 - C ) electrician. C1. “Total Hardness Test” indicator paper C2.
5. TURNING THE APPLIANCE ON To enable the function, proceed as follows: 1. Press the MENU/ESC button (B14) to enter the menu; Please note! 2. Press < (B4) or > (B8) (fig. 9) until “Rinsing” appears on Before turning the appliance on, make sure the main switch the display (B13);...
7.6 Auto-start 4. Press the OK button to enable or disable the cup warmer (the message “Cup warmer Enabled” indicates that it is You can set the auto-start time in order to have the appliance active); ready at a certain time (for example in the morning) so you can 5.
7.12 Setting the language how many times the water softener lter has been replaced. To modify the language of the display (B13), proceed as follows: 5. Press the MENU/ESC button twice to exit the menu. 1. Press the MENU/ESC button (B14) to enter the menu; 2.
8.4 Adjusting the coffee mill • While the machine is making coffee, delivery can be inter- rupted at any moment by pressing any button. The coffee mill is set by default to prepare coffee correctly and • At the end of delivery, to increase the quantity of coffee in should not require regulating initially.
8.9 Making LONG co ee using pre-ground co ee • For a denser more even froth, you must use skimmed or partially skimmed milk at refrigerator temperature (about Follow the instructions in points 1, 2, 3 and 4 of the section “8.7 Making co ee using pre-ground co ee”, then press the 5°C).
4. After a few seconds, frothed milk is delivered from the milk 4. Turn the dial back to one of the froth selections. spout (D5) into the cup below. Then the machine automat- 5. Remove the milk container (D) and always clean the hot ically makes the coffee after delivering the milk.
7. Once the required quantity of coffee has been delivered 3. Press the button (B8). After a few seconds, the steam into the cup, press the OK button again. Coffee delivery to heat the liquid comes out of the cappuccino maker/hot stops.
11. CLEANING To clean (with the machine on): • Remove the drip tray (A12) (fig. 31), empty and clean. 11.1 Cleaning the machine • Empty the grounds container (A10) and clean thoroughly The following parts of the machine must be cleaned regularly: to remove all residues left on the bottom.
2. Remove all the residues with a vacuum cleaner (fig. 34). 4. Press the two coloured release buttons inwards and at the same time pull the infuser outwards (fig. 37); 11.6 Cleaning the water tank 5. Soak the infuser in water for about 5 minutes, then rinse under the tap.
11.10 Cleaning the milk container 12. DESCALING To keep the frother efficient, clean the milk container (D) every Descale the machine when the message “DESCALE” flashes on two days as described below: the display (B13). 1. Remove the lid (D2). Important! 2.
13.1 Measuring water hardness played and the descaling procedure begins. The descaler liquid comes out of the ca ee spouts and hot water spout 1. Remove the “TOTAL HARDNESS TEST” indicator paper (C1) and a series of rinses and pauses is performed to remove from its pack (attached to the English instructions).
14.2 Replacing the lter 3. To activate the lter, run tap water through the hole in the lter as shown in the gure until water comes out of the When “REPLACE FILTER” appears on the display (B13), after two openings at the side for more than a minute ( g. 47). months (see date indicator) or when the appliance has not been used for 3 weeks, you should replace the lter (C4): 0,5 L...
16. DISPLAYED MESSAGES DISPLAYED MESSAGE POSSIBLE CAUSE SOLUTION FILL TANK Insu cient water in the tank (A16). Fill the tank with water and/or insert it cor- rectly, pushing it as far as it will go until it clicks into place. EMPTY GROUNDS CONTAINER The grounds container (A10) is full.
INSERT TANK The tank (A16) is not correctly in place. Insert the tank correctly and press as far as it will go. GENERAL ALARM The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly, as described in section “11. CLEANING”. If the message is still displayed after cleaning, con- tact a service centre.
Page 24
The co ee is delivered too slowly or a The co ee is ground too nely. Turn the grinding adjustment dial (A5) one drop at a time. click clockwise towards "7" while the co ee mill is in operation ( g. 14). Continue one click at a time until co ee delivery is satisfactory.
Page 25
De’Longhi Appliances via Seitz, 47 31100 Treviso Italia www.delonghi.com...
Need help?
Do you have a question about the ECAM45.76 Series and is the answer not in the manual?
Questions and answers