Acquiring Feature Licenses - Lenovo Flex System EN2092 User Manual

1. Log on to the management module CLI as described in the switch CLI Reference
2. Set the environment to the bay where you installed the switch. For example:
3. Type the reset command to restart the switch. Wait approximately 100 seconds
4. Type the info command for the switch that was just restarted and note the

Acquiring feature licenses

Licenses are available that enable the use of additional ports on the switch:
v Base product: Twenty-four 1 Gb full duplex throughput arranged as fourteen 1
v
v Upgrade 2: Adds eighty-eight 1 Gb full duplex throughput arranged as
Upgrade licenses are unique to each switch and are nontransferable.
To acquire an upgrade license activation key, purchase the Authorization Code and
locate the unique ID (UID) on the switch module serial number (SN) label (bottom
or rear of switch module). The UID is the last twelve characters of the switch serial
number. The serial number is located on the part number (PN) label (bottom or
rear of unit) and is also displayed during a login to any of the user interfaces. For
example: SN (UID): Y250CM294998. For more information about locating the
switch identification labels, see the section "Before installing the switch module".
In the event of a switch replacement, new activation key files based on the serial
number of the replacement unit must be acquired and installed. If the replacement
is handled through IBM Service and Support, the original Authorization Code is
transferred to the serial number of the replacement unit.
The upgrade licenses can be acquired using the System x Features on Demand
website http://www.ibm.com/systems/x/fod/.
Guide. If necessary, obtain the IP address of the management module from your
system administrator.
system> env -T system:switch[1]
for POST to complete.
system:mm[1]> env -T system:switch[1]
system:switch[1]> reset
corresponding level of the firmware for the switch. Confirm that the firmware
build number reflects the correct firmware release:
system:switch[1]> info
...
Boot ROM
Rel date:
Version:
Status: Active
Main application
Rel date:
Version:
Status: Active
Main application
Rel date:
Version:
Status: Inactive
Gb ports down and ten (RJ-45) 1 Gb ports up.
Upgrade 1: Adds forty-eight 1 Gb full duplex throughput arranged as
twenty-eight 1 Gb ports down and twenty (RJ-45), 1 Gb ports up.
twenty-eight 1 Gb ports down and twenty (RJ-45) 1 Gb ports up, and four 1 Gb
or 10 Gb SFP+ uplink ports up.
04/18/2013
7.7.1.12
04/18/2013
7.7.1.12
04/18/2013
7.7.1.12
Chapter 3. Updating the firmware and licensing
25