Installing An Sfp+ Module; Removing An Sfp+ Module - Lenovo Flex System EN2092 User Manual

DANGER
Some laser products contain an embedded Class 3A or Class 3B laser diode.
Note the following.
Laser radiation when open. Do not stare into the beam, do not view
directly with optical instruments, and avoid direct exposure to the beam.
Class 1 Laser Product
Laser Klasse 1
Laser Klass 1
Luokan 1 Laserlaite
`
Appareil A Laser de Classe 1

Installing an SFP+ module

The SFP+ module provides two fiber-optic cable connectors for connecting to
external ports. To install an SFP+ module, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
on page 6.
2. If you have not already done so, touch the static-protective package that
contains the SFP+ module to an unpainted metal surface of the Flex System
chassis or an unpainted metal surface on any other grounded rack component in
the rack in which you are installing the switch for at least 2 seconds.
3. Read the information in "Handling an SFP+ module" on page 12.
4. Remove the SFP+ module from its static-protective package.
5. Remove the protective cap, if one is installed, from the SFP+ module port
where you are installing the SFP+ module and store it in a safe place.
6. Remove the protective cap from the SFP+ module and store it in a safe place.
Attention: To avoid damage to the cable or the SFP+ module, make sure that
you do not connect the fiber optic cable before you install the SFP+ module.
7. Insert the SFP+ module into the SFP+ module port until it clicks into place.
8. Connect the fiber optic cable (see "Connecting the SFP+ module cable" on page
10) and any cables that you disconnected earlier.

Removing an SFP+ module

To remove an SFP+ module, complete the following steps:
Chapter 2. Installing the switch
13