Ruckus Wireless ZoneFlex 7762-S Installation Manual page 25

Figure 13. Connect the Ethernet cables and power adapter to the PoE injector
To AP
You have completed connecting the Access Point to the network and to a PoE power
source.
Use DC Power
To use DC to power the Access Point, you need to assemble the DC cord connector, and
then plug it into the 12V DC connector on the AP. To complete this task, you will need:
A 0.195" to 0.265" outside diameter, two-conductor DC cable. Gage depends on the
■
length. Total round trip resistance must be less than 0.4 ohm. This means no more than
seven meters of 20 gage copper. The insulation should comply with local code
requirements. Make sure that the cable that is long enough to connect the AP (at its
mounting location) with the DC power source.
A pair of long nose pliers
■
A soldering gun (optional)
■
To assemble the DC cord connector and supply DC power to the AP
1. Take the small plastic bag containing the DC connector pins and DC cord connector
from the AP package. Take its contents out.
2. Feed the end of the DC cable through the boot, cable clamp housing, and coupling
ring (in the same order). See
Configuring for Management by ZoneDirector
To AC power source
Figure 14.
Configuring the Access Point
To network
19