Specifications - Sanyo AWM-2100 Service Manual

SPECIFICATIONS

(This is basic specification)
(AMPLIFIER SECTION)
Output power ........................ 5 w x 2 (at 4 ohms, 10% distortion)
Sound presets ....................... 4 electronic presets
Bass expander ...................... +8dB ( at low volume level)
VIDEO in (AUDIO) ................ 400 mV/50 kohms
Inputs .................................... VIDEO : 400 mV/50k ohms
Outputs .................................. SPEAKER : 4 ohms
(TUNER SECTION)
(FM)
Frequency range ................... 87.5 - 108 MHz (200kHz steps)
Usable sensitivity .................. 26 dBf (mono)
(AM)
Frequency range ................... 530 kHz - 1710 kHz (10kHz steps)
Usable sensitivity .................. 200 µ V/m (AM loop antenna)
(CASSETTE DECK SECTION)
Track System ........................ 4-track, 2-channel stereo
Erasing System ..................... Magnet erase
Frequency response ............. 25 Hz to 8 kHz
Wow / Flutter ......................... 0.3%(WRMS)
Fast forward/rewind time ....... Approx. 120 sec. (C-60)
Signal-to-noise ratio .............. 45 dB
Tape speed ........................... 4.75 cm/sec.
(CD SECTION)
Type ...................................... Changer, 3disc
Channels ............................... 2 channel stereo
S/N ratio ................................ 60 dB
Wow / Flutter ......................... Below measurable limits
Sampling frequency .............. 44.1 kHz
Quantization .......................... 16 bits linear/ch
Pick-up .................................. Optical 3-beam
Pickup wave length ............... 790 nm
Laser output .......................... Continuous wave max. 0.6 mW
Frequency response ............. 20 Hz to 10 kHz
PHONES : 32 ohms
Semi-conductor laser
(GENERAL)
Power source ................ AC : 110 - 120/220 - 240V, 50/60Hz (PA)
AC : 230 - 240V , 50Hz
AC : 120V , 60Hz
Power consumption ...... 42W
Dimensions ................... 279 (W) x 290 (H) x 348 (D) mm
Weight (approx.) ............ 5.8 kg
(RB-S200 WIRELESS REMOTE CONTROL)
Power requirements ...... 2 "AA" batteries
Dimensions ................... approx. 55(W) x 163(H) x 3(D) mm
Weight ........................... approx. 85g ( without batteries)
(AWM-2100SP SPEAKER SYSTEM)
Type .............................. Full range bass reflex
Drivers ........................... 4.7" Dia (12 cm)
Unit used ....................... 12 cm cone type
Maximum power-handling capacity
...................................... 10 W (peak)
Nominal impedance ...... 4 ohms
Dimensions ................... 191 (W) x 290 (H) x 183 (D) mm
Weight (approx.) ............ 1.4 kg (per speaker)
(SX-SR2100 SURROUND SPEAKER SYSTEM) (US , CA)
Type .............................. Full range
Drivers ........................... 3.1" Dia (8 cm)
Unit used ....................... 12 cm cone type
Maximum power-handling capacity
...................................... 7 W (peak)
Nominal impedance ...... 6 ohms
Dimensions ................... 168 (W) x 88 (H) x 120 (D) mm
Weight (approx.) ............ 340 g (per speaker)
Specifications subject to change without notice.
- 1 -
(AU,XE)
(US,CA)