Do not use with incompatible components or alter this product in any way outside of the instructions provided by Horizon Hobby, LLC. This manual contains instructions for safety, operation and maintenance. It is essential to read and follow all the instructions and warnings in the manual, prior to assembly, setup or use, in order to operate correctly and avoid damage or serious injury.
Table of Contents Transmitter and Receiver Binding ......4 Flying Tips and Repairs ........11 Missile Rail Installation .........4 Post Flight Checklist ...........12 Ventral Fin Installation ...........5 Troubleshooting Guide ........12 Decal Installation ..........5 Limited Warranty ..........13 ESC/Receiver Arming, Battery Installation and Warranty and Service Contact Information ..15 Center of Gravity ...........6 IC Information .............15 Control Centering ..........7...
Transmitter and Receiver Binding For a list of compatible DSM2/DSMX transmitters, please visit www.bindnfl y.com Binding Procedure ® CAUTION: When using a Futaba transmitter with a Spektrum DSM module, you must reverse the throttle channel and rebind. Refer to your Spektrum module manual for binding and failsafe instructions. Refer to your Futaba transmitter manual for instructions on reversing the throttle channel.
Ventral Fin Installation Required Adhesives: Foam Safe CA and Accelerator. 1. Use foam safe CA (Cyanoacrylate) to secure the left and right ventral fins to the bottom side of the fuselage as shown. Tip: The ventral fi ns will have an “L” or “R” indicator on the underside.
ESC/Receiver Arming, Battery Installation and Center of Gravity NOTICE: Always keep material or debris away from the intake. When armed, the rotor will turn in response to throttle movement and could ingest in any loose objects. Arming the ESC/receiver also occurs after binding as previously described, but subsequent connection of a fl...
Control Centering Before the fi rst fl ights, or in the event of an accident, make sure control surfaces are centered when the transmitter controls and trims are neutral. The transmitter sub-trim must be set to zero. Adjust the linkages mechanically if the control surfaces are not centered.
Dual Rates and Expos To obtain the best fl ight performance, we recommend using a DSM2/DSMX transmitter Dual Rates Expos capable of Dual Rates and Expo. Before binding, High High ensure that you are starting with a blank acro model in your transmitter. Set wing type and servo Aileron 100% reversing to normal.
Control Direction Test You should bind your aircraft and Transmitter Aircraft Reaction transmitter before doing these tests. Command Move the controls on the transmitter to Down make sure the aircraft control surfaces Elevator move correctly and in the proper direction. Make sure the tail linkages move freely and that paint or decals are not adhered to them.
AS3X Direction Test Aircraft You should bind your aircraft and AS3X Reaction movement transmitter before doing these tests. Move the controls on the transmitter to make sure the aircraft control surfaces move correctly and in the proper direction. Make sure the tail linkages move freely and that paint or decals are not adhered to them.
Flying Tips and Repairs Range Check your Radio System During fl are, keep the wings level and the airplane pointed into the wind. Gently lower the throttle while After fi nal assembly, range check the radio system pulling back on the elevator to bring the aircraft with the aircraft.
Post Flight Checklist Disconnect the flight battery from the ESC Store the flight battery apart from the (Required for safety and battery life). aircraft and monitor the battery charge. Power OFF the transmitter. Make note of the flight conditions and flight plan results, planning for future flights.
Zero and adjust linkages mechanically Limited Warranty What this Warranty Covers Horizon Hobby, LLC, (Horizon) warrants to the OTHER THAN THE EXPRESS WARRANTY ABOVE, original purchaser that the product purchased (the HORIZON MAKES NO OTHER WARRANTY OR “Product”) will be free from defects in materials and REPRESENTATION, AND HEREBY DISCLAIMS ANY workmanship at the date of purchase.
Page 14
Horizon reserves the right to inspect any and all Product securely using a shipping carton. Please Product(s) involved in a warranty claim. Service or note that original boxes may be included, but are replacement decisions are at the sole discretion not designed to withstand the rigors of shipping of Horizon.
Compliance Information for the European Union Instructions for disposal of WEEE by users in the European Union EFL UMX F-16 BNF Basic (EFLU2850) This product must not be disposed EU Compliance Statement: Horizon Hobby, LLC of with other waste. Instead, it is the hereby declares that this product is in compliance user’s responsibility to dispose of their...
Fusoliera con Accessories: UMX Rumpf mit Zubehör accessori: UMX F-16 EFLU2858 F-16 Main Wing Set and E-Flite UMX F-16: UMX F-16 - Aile avec Set ala e supporti EFLU2859 Missile Rails: UMX Tragfl äche mit pylônes missiles missili: UMX F-16 F-16...
– Optional Parts and Accessories – – Optionale Bauteile und Zubehörteile – – Pièces optionnelles et accessoires – – Parti opzionali e accessori – Part # • Nummer Description Beschreibung Description Descrizione Numéro • Codice Hook and Loop Set Klettband (5): Ultra Bande auto- Set fascette fi...
Need help?
Do you have a question about the UMX F-16 and is the answer not in the manual?
Questions and answers