Connecting To A Dvd Player Via Component Sockets (Ypbpr) Or Scart Cable; Remote Control Handset; Inserting Batteries; Switching On/Off - Sanyo LCD-22VT11DVD Instruction Manual

Connecting to a DVD Player
via Component Sockets
(YPbPr) or Scart Cable
• Some DVD players are connected through
COMPONENT SOCKETS (YPbPr). In this case,
you must use the supplied Component video
connection cable for enabling connection. First,
plug single jack of the cable to the TV's YPbPr
socket (side). Afterwards, insert your component
cable's (not supplied) connectors into the plural
part of the Component video connection cable (see
illustration below). Colours of the connected jacks
should match.
• To enable audio connection, use the
Component Audio cable. First, plug single jack
of the cable to the TV. Afterwards, insert your DVD
player's audio cable's connectors into the plural part
of the VGA/Component audio connection cable
(see illustration below). Colours of the connected
jacks should match.
• When the connection is made, switch to
YPbPr source. See, Input selection section.
Note: To connect Y Pb Pr device, you should use
supplied component (YPbPr) connection cable
• You may also connect through the
Scart Cable
(not supplied)
External device

Inserting Batteries

•
•
VGA/
Note: Remove the battery from remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.

To Switch the TV On

Connect the power cord to the 220-240V AC 50 Hz.
•
•
•
SCART input.
•
•
Note: If you switch on your TV via standby button
on the remote control, the programme/source that
you were watching last will be reselected.
By either method the TV will switch on.

To Switch the TV Off

•
•
Note: When the TV is switched to standby mode,
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active.
English - 10 -

Remote Control Handset

Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
Insert two AAA/R3 or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.

Switching On/Off

Switch the " " button to position "|" so the TV
will switch to standby mode. Then the standby LED
lights up.
To switch on the TV from standby mode either:
Press the " " button, P+ / P- or a numeric button
on the remote control.
Press the " " or PCH+ / PCH- button on the TV.
The TV will then switch on.
Switch the " " button to position 2 as illustrated,
so the TV will switch OFF.
To power down the TV completely, unplug the power
cord from the mains socket.