Viewing The Connections - Side Connectors; Power Connection; Aerial Connection - Sanyo LCD-22VT11DVD Instruction Manual

5. S/PDIF Coaxial Out
Use an SPDIF coaxial cable to trasfer audio signals to a device that has S/PDIF input

Viewing the Connections - Side Connectors

1. CI Slot is used for inserting a CI card. A CI card allows you to view all the
channels that you subscribe to. For more information, see "Conditional Access"
section.
2. Side USB input.
3. TV control buttons.
4. Component Video Input (YPbPr)
You can connect the component video and audio sockets with a device that
has component output. To do this, you must use the supplied component video
connection cable for enabling connection. First, plug single jack of the cable to
the TV's YPbPr socket (side). Afterwards, insert your component cable's (not
supplied) connectors into the plural part of the Component video connection
cable. Colours of the connected jacks should match.
5. Side audio-video connection
signals of external devices. To make a video connection, you must use the
supplied AV connection cable for enabling connection. First, plug singular jack of
the cable to the TV's Side AV socket. Afterwards, insert your video cable's (not
supplied) connector into the YELLOW input (located on the plural side) of the
supplied AV connection cable. Colours of the connected jacks should match.
To enable audio connection, you must use RED and WHITE inputs of the side AV
connection cable. Afterwards, insert your device's audio cable's connectors into
the RED and WHITE jack of the supplied side AV connection cable. Colours of
the connected jacks should match.
Note: You should use audio inputs of side AV connection cable (RED & WHITE)
to enable sound connection when connecting a device to your TV by using PC or
COMPONENT VIDEO input.
6. Headphone jack is used for connecting an external headphone to the system.
Connect to the HEADPHONE jack to listen to the TV from headphones (optional).
7. , switch is used for turning the TV on or off.

Power Connection

IMPORTANT: The TV set is designed to operate on 220-240V AC, 50 Hz.
• After unpacking, allow the TV set to reach the ambient room temperature before you connect the set to the
mains. Plug the power cable to the mains socket outlet.

Aerial Connection

• Connect the aerial ,cable TV plug to the AERIAL INPUT socket located at the rear of the TV.
outputs digital audio signals of the currently watched source.
is used for connecting component video.
input is used for connecting video and audio
English - 8 -