Aligning Manually And Cutting - Roland VersaCamm VP-540 User Manual

To Quit Detection and Start Cutting
CANCEL CROPMARK
DETECTION?
Press .
This stops detection and starts cutting.
Note: After pressing
P. 68, "Pausing or Canceling Output"

Aligning Manually and Cutting

Depending on the type of media, it may not be possible to detect crop marks automatically. When crop marks cannot
be detected automatically, you perform alignment manually.
Procedure
1.
Set the base point.
W1100mm
B
Press .
Crop-mark detection stops. Depending on the content of the data, some time
may pass before detection actually stops.
in step , resuming detection or canceling output is also possible.
4-9 Performing Printing and Cutting Separately
Use
center of the blade with the location shown in
the figure.
Press .
Press .
Chapter 4 Feature Reference
to align the
97