Related Manuals for Ebac CD100
Summary of Contents for Ebac CD100
- Page 1 Drawing : - TPC112 Issue : - 3 Date : - 03/10/12 C C C C D100 D100 D100 D100 DEHUMIDIFIER DEHUMIDIFIER DEHUMIDIFIER DEHUMIDIFIER OWNER’S MANUAL OWNER’S MANUAL OWNER’S MANUAL OWNER’S MANUAL www.eipl.co.uk Page 1 of 13...
-
Page 2: Package Contents
Drawing : - TPC112 Issue : - 3 Date : - 03/10/12 CD100 PACKAGE CONTENTS Item Description Quantity 1133560 Dehumidifier 3014338 PVC Tube – 12mm I/D 3086101 Jubilee clip TPC112 Manual Page 2 of 13... - Page 3 The CD100 dehumidifier is a rugged reliable drying unit designed to operate effectively over a broad range of temperature and humidity conditions. A...
-
Page 4: Specifications
"This product contains fluorinated greenhouse gases covered by the Kyoto Protocol. The refrigeration system is hermetically sealed. The Global Warming Potential (GWP) of refrigerants used in products manufactured by Ebac Industrial Products Ltd is as follows R134a – 1300 R407c –... - Page 5 Failure to observe this requirement will result in flooding of the dehumidifier unit. The CD100 may also be fitted with a water pump (optional), which is capable of discharging the condensate water 30ft away from the unit. The water can, therefore, be discharged into a drain some distance away.
-
Page 6: Operation
6. Ensure the condensate drains away from the machine. Setting the Adjustable Humidistat The position of the humidistat depends on the application the CD100 is being used for and the conditions within the area to be dried. The worse the conditions within the area then the higher the humidistat should be set (i.e. - Page 7 The pump is capable of discharging water to a vertical height of 30ft. Indicator Panel The CD100 is fitted with an indicator lamp to show when power is available and the unit is switched on, if this does not appear to be functioning correctly then refer to the repairs section.
-
Page 8: Routine Maintenance
Drawing : - TPC112 Issue : - 3 Date : - 03/10/12 ROUTINE MAINTENANCE WARNING: ENSURE THAT THE POWER CORD TO THE MACHINE HAS BEEN DISCONNECTED BEFORE CARRYING OUT ROUTINE MAINTENACE ON ITEMS 1, 2, 3, AND 4. To ensure continued full efficiency of the dehumidifier, maintenance procedures should be performed as follows: Removal of the cover is achieved by means of four screws at the sides of the unit at base level. - Page 9 Drawing : - TPC112 Issue : - 3 Date : - 03/10/12 REPAIRS Should an electrical component fail, consult the Factory Service Center to obtain the correct replacement part. If refrigerant gas is lost from the machine, it will be necessary to use a refrigeration technician to correct the fault.
-
Page 10: Troubleshooting
Drawing : - TPC112 Issue : - 3 Date : - 03/10/12 TROUBLESHOOTING YMPTOM AUSE EMEDY 1. Tighten fan 2. Replace the fan motor 1. Loose fan on shaft 3. See Routine Maintenance 2. Fan motor burnt out Section Little or no airflow 3. - Page 11 : - 3 Date : - 03/10/12 UK Head Office American Sales Office German Sales Office Ebac Industrial Products Ltd Ebac Industrial Products Inc Ebac Industrial Products Ltd St Helens Trading Estate 700 Thimble Shoals Blvd. Miraustra 64 – 66...
-
Page 12: Limited Warranty
This warranty will cover all parts and labour required to repair your Ebac product. This warranty is invalid if the unit has been abused, damaged, whether intentional or accidental, or if any modifications have been made to the unit. - Page 13 : - 3 Date : - 03/10/12 UK Head Office American Sales Office German Sales Office Ebac Industrial Products Ltd Ebac Industrial Products Inc Ebac Industrial Products Ltd St Helens Trading Estate 700 Thimble Shoals Blvd. Miraustra 64 – 66...
Need help?
Do you have a question about the CD100 and is the answer not in the manual?
Questions and answers