Sharp XG-V10XE Service Manual page 34

XG-V10XE
No. Adjusting point
34 Lens perform-
ance checking
35 Delivery set-
tings
The methods of color correction adjustment, after LCD panel is replaced.
When not use color correction system.
No. Adjusting point
1 Color correction
Rest
2 Saw-tooth wave
Correction (G),
(R)
Adjusting conditions
1. When the S3 delivery set-
tings have been made, the
SET-UP signal is no accept-
able.
Adjusting conditions
1. Make the following choice.
Group : NOKO
Subject : CC
1. Feed the gray only RGB
color signal. (XGA 60Hz)
2. Check for uneven color spot
on the screen.
3. Make the following choice.
Group : NOKO
Subject : NOKO-G
Choose the subject NOKO-
R for the R Color.
Adjusting procedure
» Using the set's control switch or the remote control-
ler, make sure the focus, zoom, keystone and lens
shift actions are as specified.
» Make the following settings.
Remote controller
Process
adjustment setting
Delivery setting 3
S3 "
Adjusting procedure
» Make the following setting.
Subject : CC
Setting : 0 (color correction OFF)
» If the color is irregular, adjust the setting NOKO-G
or NOKO-R to minimize the right-hand and left-hand
color irregularity.
» If there is no color irregularity, turn off the saw-tooth
correction using SW4201 (green) and SW4202 (red).
34
"