Remote Mounting Of The Control (Wired) - GE ZVC30LSS Installation Instructions Manual

REMOTE MOUNTING OF THE CONTROL
(WIRED)
WARNING:
power from unit before beginning remote control
installation. Failure to do so could result in personal
injury or damage to the electrical controls.
AVERTISSEMENT :
débrancher l'alimentation électrique de l'appareil
avant de commencer l'installation de la commande
à distance. Il faut suivre cette directive pour éviter
des blessures ou endommager les commandes
électriques.
Installation Preparation
Disconnect electrical
Il faut
REMOTE LOCATION FOR CONTROL
The control can be removed from the hood and
installed in a backsplash or countertop.
• A cover plate is provided to cover the opening in
the hood when the control is removed.
• A 30-ft. length of 4-wire cord is supplied to
accommodate most installations. Because only
30-ft. of cord is provided, careful consideration
must be given to the location of the remotely
mounted control.
NOTE: Not for telecommunication (telephone)
network.
• The cord must be routed through the holes in the
insert sleeve, and the rubber grommets put into
place around the cord.
NOTE: On the ZVC30 and ZVC36 models, the cord
needs to be routed through the holes in the insert
sleeve before the damper plate is installed.
• Route the cord through the conduit to reach the
installation location of the control.
1-11/16"
14
3-11/16"
Control cutout