Simple Length Measurement; Area Measurement; Volume Measurement; Continuous Measurement (Tracking) /Minimum/Maximum Measurement - Bosch GLM 80 Operating And Safety Instructions Manual

Measuring Functions

Simple Length Measurement

For length measurements, press
button 12
measurement"
on the display.
The measured value is displayed
in the result line c.
For several subsequent length
measurements, the last measured
results are displayed in the
measured-value lines a.

Area Measurement

For area/surface measurements,
press button 12 until the indicator
for area measurement
on the display.
Afterwards, measure the length
and the width, one after another,
in the same manner as a length
measurement. The laser beam
remains switched on between
both measurements.
displayed in the result line c. The
individual measured values are
displayed in the measured-value
lines a.
until the "length
indication appears
To switch the laser
on and
measuring, briefly
press
measuring button
2 once each time.
appears
Upon completion
of the second
m e a s u r e m e n t ,
the surface
a u t o m a t i c a l l y
calculated

Volume Measurement

For volume measurements, press
button 12 until the indicator for
volume measurement
on the display.
Afterwards, measure the length,
width and the height, one after
another, in the same manner as
for
for a length measurement. The
laser beam remains switched on
the
between all three measurements.
result line c. The individual
measured values are displayed in
the measured-value lines a.
Values above 999999 m3 cannot
be indicated; "ERROR" appears
on the display. Divide the volume
to be measured into individual
measurements; their values can
then be calculated separately and
then summarized.
Continuous Measurement
(Tracking) / Minimum/Maximum
Measurement (see figure B)
For continuous measurements,
the measuring tool can be moved
relative to the target, whereby the
is
measuring
approx. every 0.5 seconds. In this
and
manner, as an example, you can
move a certain distance away
from a wall, while the actual
distance can always be read.
-23-
appears
Upon completion
of the
m e a s u r e m e n t ,
the volume
a u t o m a t i c a l l y
calculated
displayed in the
value is updated
third
is
and