Toro Groundsmaster 4000-D Service Manual page 230

5. Remove the knuckle pin mounting bolts and the
knuckle pin. Remove the gasket and any remaining gas-
ket material from both mating surfaces (Fig. 18).
6. While holding the bevel gear case, tap the upper end
of the bevel gear shaft out of the upper bearing and up-
per bevel gear.
7. Pull the bevel gear case from the axle case and re-
move the upper bevel gear and collar from the gear
case.
8. Remove the axle case cover screws, cover and the
O-ring from the axle case.
9. Remove the plug (not shown) and sealing washer
from the center of the axle case cover. While holding the
axle case cover, lightly tap the lower end of the bevel
gear shaft out of the lower bearing and lower bevel gear.
10.Remove and discard bevel gear shaft seal from axle
case (Fig. 18).
Bevel Gear Case and Axle Case Inspection
1. Measure the knuckle pin O.D. and the axle case sup-
port bushing I.D. to determine the bushing to pin clear-
ance (Fig. 19). Replace components as necessary.
BUSHING TO PIN CLEARANCE:
0.002 to 0.016 in. (0.05 to 0.40 mm)
KNUCKLE PIN O.D. (Factory Spec.):
0.982 to 0.983 in. (24.95 to 24.98 mm)
AXLE CASE SUPPORT BUSHING I.D.
(Factory Spec.):
0.984 to 0.987 in. (25.00 to 25.08 mm)
2. Inspect all gears, shafts, bearings, cases and covers
for damage and wear. Replace components as neces-
sary.
Axles, Planetaries and Brakes
2
17 to 20 ft- -lb
(23 to 27 N- -m)
Threadlocking
Compound
5
7
8
6
9
10
(23 to 27 N- -m)
1. Knuckle pin
2. Bolt (4 used)
3. O- -ring
4. Bevel gear case
5. Upper bearing
6. Bevel gear shaft
7. Collar
8. Upper bevel gear
1
2
1. Knuckle pin
Page 6 - - 18
1
3
4
17 to 20 ft- -lb
Figure 18
9. Lower bevel gear
10. Lower bearing
11. Axle case
12. Axle case cover
13. O-ring
14. Shaft seal
15. Bushing
Figure 19
2. Axle case support
Groundsmaster 4000--D
14
11
15
13
12