Gcu Connection - dji Zenmuse Z15-5D User Manual

The GCU Connection
The GCU Connection
Battery
(4S~12S)
Wireless Video
Transition Module
Air End
Ensure the side with copper contacts is
facing upward towards the heat sinks.
 Make sure the battery voltage is in the required range of both the aircraft and the gimbal if you use only one battery for
power supply.
A2/WKM/ACE ONE/ACE Waypoint
Refer to the A2/ WKM/ACE ONE/
ACE Waypoint User Manual for more
connection and configuration details.
 Above are example connections, which require two transmitters and two receivers. One transmitter and receiver are used
for gimbal control and the other are used for aircraft control. Users can also use a transmitter and a receiver to control
both the gimbal and aircraft.
 Configure the Aileron, Elevator, Rudder channels on the transmitter for gimbal control. Command stick stands for the
gimbal rotation velocity，the center position is for 0 and the endpoint for maximum velocity (both clockwise and counter
clockwise directions). (End Point is 100%)
 Choose one 3-position switch/channel as the Z15 working modes switch.(MODE)
 Choose one 2- position switch/channel as the camera shutter control switch(SHUT), one for the camera lens orientation
switch in Reset Mode (AUX2).
 Please refer to the A2/ WKM/ACE ONE/ACE Waypoint User Manual for aircraft control setting.
 Connect the receiver to GCU correctly.
* When using with A2 latest firmware version 2.5, all of the gimbal channels can be setup through the A2 receiver.
Refer to A2 User Manual for details.
©2013 DJI Innovations. All Rights Reserved.
Micro-USB Port
PC connection for configuration and
firmware upgrades via a Micro-USB
cable.
Make sure the ports are accessible when installing the GUC so as to facilitate

wiring and software configuration.
In 3-pin ports, pins near the nicks are the signal pins.

DO NOT cover the heat sinks, keep them unobstructed.

The GCU module is NOT water-proof or oil-proof.

Transmitter and Receiver
A2/WKM/
ACE ONE/
ACE Waypoint
5D
Heat
Sinks
G8
Reserved &
Disconnected
Battery
Gimbal Controller (GCU)
RC Receiver
(Aircraft control)
2-Position Switch
2-Position Switch
2-Position Switch
AUX2 RC Receiver
RUDD (JR)
ELEV
AILE
8-Channel
Or
8-Channel
1
2
RC Receiver
4
(Futaba
7
/ Hitec)
2-Position Switch
2-Position Switch
2-Position Switch
Or
S-Bus
S-Bus Receiver
(Futaba)
Or
PPM
PPM Receiver
CAN-Bus port of GCU
For WKM/ACE ONE/ACE
Waypoint, connect to any spare
CAN-Bus port of the flight
control system via a CAN-Bus
cable.
For A2, connect to the CAN2 or
CAN1 port.
15