Lcd Error Messages And Descriptions - Tharo Systems H-427 Parts & Service Manual

LCD Error Messages and Descriptions

LCD
Message
Ribbon
Printhead is
opened
Entering the
Cooling Process
Out of ribbon or
check ribbon
sensor
Out of media or
check media gap
sensor
Check paper
setting
CF Card not found
Memory Full
Rewinder Full
Filename cannot be
found
Filename repeated
NOTICE!
The Printer repeats all warning beeps.
Printhead is opened, the Printer will beep four times, pause, and then beep
four more times.
Blinking
Quickly
LED Lights
Beep
Media
Blinking Slowly
Description
The Printhead not firmly
4
locked in place.
Printhead temperature is too
high.
No ribbon is installed and
using Direct Thermal stock.
3
The ribbon is used up or the
Ribbon Supply Shaft is not
moving.
The moveable sensor is
unable to detect paper.
1
The label stock is used up or
label sensor can't detect
paper.
1 Improper paper feed.
CF Card is not installed or
2
installed incorrectly.
2 Memory is full.
2 The Rewind is full.
2 Cannot find the file.
Another file with this name
2
exists.
For example when the Printer's
Steady
Solution
Re-open the Printhead and make
sure it closes tightly.
Printer goes back to standby
mode after cooling.
Make sure the Printer is in Direct
Thermal mode.
Replace with new ribbon roll.
Make sure the movable sensor
mark is at the correct position. If
the sensor is still unable to detect
the paper, then go through the
Auto Sensing steps again.
Replace with new roll of labels. If
the moveable sensor is still not
able to detect the paper, then go
through the Auto Sensing steps
again.
Possible causes:
1. Media falling into the gap
behind the platen roller.
2. Can't find label gap/black
mark. Perform Auto
Sensing procedure.
3. Black mark paper out.
Install the CF Card correctly.
Delete unnecessary data in the
memory.
Remove the labels from the
Rewind.
Use "~X4" command to print out
all the files and check whether
the file exists and if the name is
correct.
Change the file name and
download again.
32