1. Manuals
  2. Brands
  3. Viking Range Manuals
  4. Ranges
  5. 30" W. Models
  6. Installation instructions manual

Viking Range 30” W Installation Instructions Manual

Dual fuel ranges
Hide thumbs Also See for 30” W:
Table of Contents

Advertisement

Quick Links

See also: Installation Manual
INSTALLATION
INSTRUCTIONS
DUAL FUEL RANGES
IMPORTANT - PLEASE READ AND FOLLOW
•Before beginning, please read these instructions completely and carefully.
•Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty.
•Please observe all local and national codes and ordinances.
•Please ensure that this product is properly grounded.
•The installer should leave these instructions with the consumer who should retain for local inspector's use and for future
reference.
Installation must conform with local codes or in the absence of codes, the National Fuel Gas Code ANSI Z223.1-latest
edition. IN CANADA: Installation must be in accordance with the current CAN/CGA B149.1 & 2 Gas Installation codes
and/or local codes. Electrical installation must be in accordance with the current CSA C22.1 Canadian Electrical Codes
Part 1 and/or local codes.
In Massachusetts: All gas products must be installed by a "Massachusetts" licensed plumber or gasfitter. A "T" type
handle manual valve must be installed in the gas supply line to the appliance.
Frame grounded to neutral of appliance through a link. If local codes do not permit grounding through the neutral, the
3-conductor cord or cable assembly must be replaced by a 4-conductor cord or cable assembly. See manufacturer's
instructions.
WARNING:
IF THE INFORMATION IN
THIS MANUAL IS NOT FOLLOWED
EXACTLY, A FIRE OR EXPLOSION MAY
RESULT CAUSING PROPERTY DAMAGE,
PERSONAL INJURY, OR DEATH.
1. Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
2. WHAT TO DO IF YOU SMELL GAS:
•Do not try to light any appliance.
•Do not touch any electrical switch; do not use any
phone in your building.
•Immediately call your gas supplier from a neighbor's
phone.
•Follow the gas supplier's instructions.
•If you cannot reach your gas supplier, call the fire
department.
3. Installation and service must be performed by a
qualified installer, service agency, or the gas supplier.
WARNING
If not installed, operated and maintained in
accordance with the manufacturer's instructions, this
product could expose you to substances in fuel or
from fuel combustion which can cause death or
serious illness and which are known to cause
cancer, birth defects, or other reproductive harm.
For example, benzene is a chemical which is
part of the gas supplied to the cooking
product. It is consumed in the flame during
combustion. However exposure to a small
amount of benzene is possible if a gas leak
occurs. Formaldehyde and soot are by-
products of incomplete combustion. Properly
adjusted burners with a bluish rather than
yellow flame will minimize incomplete
combustion.
WARNING!
•This range can tip.
•Injury to persons could result.
•Install anti-tip device packed with range.
•See Installation Instructions
VIKING RANGE CORPORATION
111 Front Street
Greenwood, Mississippi 38930 USA
(662) 455-1200
WARNING

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 30” W and is the answer not in the manual?

Questions and answers

Related Manuals for Viking Range 30” W

Summary of Contents for Viking Range 30” W

  • Page 1: Installation Instructions

    VIKING RANGE CORPORATION INSTALLATION 111 Front Street Greenwood, Mississippi 38930 USA INSTRUCTIONS (662) 455-1200 DUAL FUEL RANGES IMPORTANT - PLEASE READ AND FOLLOW •Before beginning, please read these instructions completely and carefully. •Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty.
  • Page 2 Specifications - Dual Fuel 30”, 36” W. and 48” W. Ranges Description 30” W. Models 36” W. Models 48” W. Models Overall width 29 7/8” (75.9 cm) 35 7/8” (91.1 cm) 47 7/8” (121.6 cm) Overall height Open Burner Sealed Burner To top of grate support - Min.

  • Page 3: General Information

    GENERAL INFORMATION 1. WARNING: The use of cabinets for storage above the appliance may result in a potential burn hazard. Combustible items may ignite, metallic items may become hot and cause burns. If a cabinet storage is to be provided the risk can be reduced by installing a rangehood that projects horizontally a minimum of 5” (12.7 cm) beyond the bottom of the cabinets.
  • Page 4 Important: Leveling/Adjustments/Alignment Closely follow the procedures below to ensure proper performance and appearance of the range. 1. If the floor is smooth and level, level the unit with the screw thread of the legs. Set the high corner of the range so that the the top of the side trim is 3/8”...

  • Page 5: Wood/Composite Overlay Installation

    WOOD/COMPOSITE OVERLAY INSTALLATION The bottom of a standard hood should be 30” (76.2 cm) min to 36” (91.4 cm) max. above the countertop. This would typically result in the bottom of the hood being 66” (167.6 cm) to 72” (182.9 cm) above the floor. Refer to the rangehood installation instructions for additional information.

  • Page 6: Proximity To Side Cabinet Installation

    Proximity to Side Cabinet Installation 1. This range may be installed directly adjacent to existing 36” (91.4 cm) high base cabinets. IMPORTANT: The side trim MUST be 3/8” (.95 cm) above the adjacent base cabinet countertop. This may be accomplished by raising the unit using the adjustment spindles on the legs.

  • Page 7: Gas Connection

    Gas Connection The gas supply (service) line must be the same size or greater than the inlet line of the appliance. This range uses a 1/2” (1.3 cm) ID NPT (Sch40) inlet. Sealant on all pipe joints must be resistive to LP gas. 1.

  • Page 8: Electrical Connection

    Electrical Connection Use a 3-wire power supply cord kit rated for 40 amps - 125/250 volts with closed loop terminals and marked for use with ranges. Do not use a GFI circuit. Where local codes do not permit grounding through neutral, use a 4-wire power supply cord.
  • Page 9 Electrical Connection With Conduit Use 1/2” (1.3 cm) trade size conduit with a conduit clamp, 12 AWG/600 volt copper conductor colored red for line 1 and black for line 2 and 14 AWG/600 volt copper conductor colored white for neutral with closed loop terminals marked for use with ranges. Where local codes do not permit grounding through neutral, use a green 12 AWG copper conductor as directed in the 4-wire connector directions.
  • Page 10 Natural to LP/Propane Conversion Instructions (Open Top Burners) This product is manufactured and adjusted for operation with natural gas as shipped from the factory. To operate with LP/Propane gas, the following adjustments should be made: 1. A pressure regulator is located in the left rear corner of the burner box. To gain access to the pressure regulator, remove the two left grates, tow burner bowls, and the left grate support.
  • Page 11 Natural to LP/Propane Conversion Instructions (Sealed Top Burners) This product is manufactured and adjusted for operation with natural gas as shipped from the factory. CAUTION: Before proceeding with conversion, turn off gas supply to the appliance and disconnect the electrical power. To operate with LP/Propane gas, the following adjustments should be made: 1.

  • Page 12: Grill/Griddle Burner Adjustment

    Grill/Griddle Burner Adjustment 12” Grill Assembly 24” Grill Assembly Grill (Item A) 1. The grill burner orifice and air shutter are located beneath the front end of the grill assembly. To gain access to the adjsutments, remove the grill grate, flavor generator plates, grate support, and the burner shield.

  • Page 13: Performance Checklist

    Replacement Parts Only authorized replacement parts may be used in performing service on the oven. Replacement parts are available from factory authorized parts distributors. Contact Viking Range Corporation Preferred Service, (888) 845-4641, for the nearest parts distributor in your area.
  • Page 16 WIRING DIAGRAM DUAL FUEL VDSC485 RANGE For connection to the factory installed terminal block use aluminum or copper conductors. WARNING: This unit must be grounded. See Installation Instructions for proper grounding procedures. NOTE: Trailers or stirpes will be the second color in a color combination.
  • Page 17 WIRING DIAGRAM CANADIAN DUAL FUEL CVDSC485 RANGE For connection to the factory installed terminal block use aluminum or copper conductors. WARNING: This unit must be grounded. See Installation Instructions for proper grounding procedures. NOTE: Trailers or stirpes will be the second color in a color combination.
  • Page 20 Viking Range Corporation 111 Front Street • Greenwood, Mississippi 38930 USA • (662)455-1200 Specifications subject to change without notice http://www.vikingrange.com F20144J (PS0905VR)

Table of Contents