Charging Traxxas Id Lipo Batteries; Charging In High Output Mode - Traxxas EZ-Peak Dual 2972 Instructions For Use

Charging Traxxas iD LiPo Batteries

1. Plug the charger into an AC wall outlet
and connect the battery/batteries
The charger will recognize the iD batteries
and show you the charge settings.
Dual Charge Mode
2. Verify the charge settings
Battery type selected must match the battery type shown on the battery.
Charge Mode
(the default is
Battery Type Balance)
LiPo Charging Modes
Change your LiPo charging mode if desired.
The default setting for iD LiPo batteries is Balance Charge.
Charge Rate Start
Storage charge
Makes it easy to charge or discharge
batteries to the proper storage
voltage. Use this mode whenever
batteries will be stored unused for
more than 7 days.
Fast charge
Fast charges batteries without
balancing your cells. Stops charging
when the first cell reaches peak voltage.
Depending on the condition of the
batteries, this may reduce the charge
time by a few minutes.
Balance charge
Always balance charge your LiPo
batteries for maximum capacity,
voltage, and battery life. This is the
default setting for Traxxas iD batteries.
The EZ-Peak Dual performs a balance
charge quickly and efficiently.
3. Charging
Press and hold the Start button(s) for 1 second. The charger will play a
tone, indicating that charging has started. Press once to stop. The charger
will play a tone, indicating that charging has been canceled. The charge
progress LEDs will light as the battery charges.
4. Charge cycle complete
The charger will play a complete tone, followed by one or two beeps to
indicate channel 1 (left) or channel 2 (right) charging is complete.
Complete
Charging Traxxas iD Batteries
in High Output Mode
High Output Mode allows you to charge high capacity batteries
at a faster charge rate. Use the high output channel to charge your
5000 mAh NiMH batteries at 5 amps and your 4000 mAh and larger
LiPo batteries at a "2C" charge rate (2C is 2 times the capacity; 4000
mAh x 2 = 8000 or 8 amps). Only one Traxxas battery at a time can be
charged in High Output Mode using the output port on the right side
of the charger (the left side of the charger is disabled). Move the switch
to High Output, and follow steps 1-4 for Traxxas iD battery charging.
Charge Cycle Progress
Cycle
(solid)
Disabled
Charging
(flashing)