Adjusting The Shift Cable - Yamaha F115A Service Manual

INSP
ADJ
a
c
3140
CONTROL SYSTEM
b
3120
3130

ADJUSTING THE SHIFT CABLE

1. Check:
• Shift operation
Incorrect → Adjust.
2. Adjust:
• Shift cable joint position
Adjustment steps
(1) Align the mark a on the bushing with
the mark b on the bracket c.
(2) Loosen the locknut 1 and remove the
clip 2.
(3) Remove shift cable joint 3 from the
set pin.
(4) Position the remote control lever in the
neutral position.
(5) Adjust the position of the shift cable
joint until it aligns with the set pin.
WARNING
The shift cable joint must be screwed in at
least 8 mm (0.31 in).
(6) Install the shift cable joint onto the set
pin.
(7) Install the clip and tighten the locknut.
(8) Move the remote control lever to the
forward, neutral, and reverse positions
and make sure it shifts smoothly and
correctly. If the shifting operation is
unsmooth or incorrect, repeat the
above procedure.
3. Check:
• Shift operation
Unsmooth operation → Repair.
3-5
E
3