Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for JBL SYNTHESIS SDA-7200
Summary of Contents for JBL SYNTHESIS SDA-7200
-
Page 1: Important Safety Precautions
SDA-7200 Multi-Channel Amplifier... -
Page 2: Table Of Contents
WHAT’S IN THE BOX Your new SDA-7200 includes the items listed below. If anything is missing please contact your dealer or installer before contacting JBL Synthesis as they may have used it to install you new product: • AC Power Cord •... -
Page 3: Front Panel Controls & Indicators
Front Panel Controls JBL SYNTHESIS SDA-7200 FRONT PANEL CONTROLS AND INDICATORS Standby Indicator Standby/ Channel Operation On Switch Indicators Standby Indicator: This LED indicator is red when the SDA-7200 when AC mains power is Channel Operation Indicators: These indicators are off when the SDA-7200 is in the Standby applied and the rear panel Master Power Switch is turned on. -
Page 4: Rear Panel Connections And Controls
Rear Panel Connections JBL SYNTHESIS SDA-7200 REAR PANEL CONNECTIONS Trigger Input Jack Audio Sense Switch CAN ICES-3(B)/ NMB-3(B) 3050166 Fuse Receptacle Input Jacks Master Power Switch 100-120V/200-240V 50/60Hz 1200W AC Power Cord Receptacle Output Terminals Input Jacks: Connect these jacks to the audio outputs of your surround processor or external EQ. -
Page 5: Connections And Configuration
Connections and Configuration JBL SYNTHESIS SDA-7200 CONNECTIONS AND CONFIGURATION First, loosen the knobs on the Output Terminals until the pass-through hole is visible. Next, pass the cable through the hole making certain that you place the “positive” cable side through the SAFETY NOTE: When making connections between the SDA-7200 and a surround top connector and the “negative”... -
Page 6: Operation
Connections and Operation JBL SYNTHESIS SDA-7200 AC POWER CONNECTION The final step in the installation of the SDA-7200 is to connect the power cord. First, connect the female end of the cord into the AC Power Receptacle on the rear panel. Once the cord as been firmly connected to the SDA-7200, insert the plug end into an AC power outlet. -
Page 7: Troubleshooting & Maintenance
If problems occur, see this section for troubleshooting information. If a problem 20Hz - 20kHz, <1%THD persists, please contact your JBL Synthesis authorized dealer or installer. 200 watts per channel, 7 channels driven at 8 ohms, 20Hz - 20kHz, <1%THD No power: •... - Page 8 8500 Balboa Boulevard, Northridge, CA 91329 USA © 2014 HARMAN International Industries, Incorporated. All rights reserved. JBL and JBL Synthesis are trademarks of HARMAN International Industries, Incorporated, registered in the United States and other countries. For customer service refer to our Web site: www.jblsynthesis.com or contact us at +1-888-691-4171.
Need help?
Do you have a question about the SYNTHESIS SDA-7200 and is the answer not in the manual?
Questions and answers