It is important that you read this entire user guide before using your mē smooth for the first time. If you have questions or concerns, please contact our Customer Care at: ILUMINAGE BEAUTY Website: www.mepower.com...
For more details about accessories, go to www.mepower.com For instructions on how to use accessories for the mē smooth refer to page 23. mē smooth is intended for use on ALL skin colours (the skin colour you were born with).
Page 4
Getting to know your mē smooth Device components Applicator components 1. Base unit 6. Light output window: the light energy flashes out through the treatment window 2. Cradle 7. RF contact bars: the two RF bars must be in complete contact with the skin for 3.
KEEP OUT OF REACH OF CHILDREN. The mē smooth should not be used by back. The hair removal results may be permanent. anyone, or on anyone, under the age of 18. The use of the mē smooth on or by DO NOT use the mē smooth if you are sensitive to light (photosensitive).
1. Clean the light output window with a non-alcohol based DO NOT use the mē smooth while bathing or put it next to a bath or sink. wet wipe or soft tissue. This is done in order to remove hairs DO NOT operate the mē...
How to use your mē smooth If you are using the mē smooth for the first time or treating a new body area, If this is your first time using the device, be sure to conduct the Skin Sensitivity Test.
Page 8
The following treatment instruction refers to treating facial areas with the bars are in complete contact with the skin. The mē smooth mē smooth. However it is recommended that you use the mē smooth with will emit pulses of bright light - this is the elōs energy at work.
• Remove the used cartridge from the applicator by holding the as you would normally. After your initial protocol, use your mē smooth for touch- cartridge´s sides and gently pulling it out. Dispose of the used ups of new hair growth as needed.
2. elōs activation button has in contact with skin. not been pressed. Make sure that the mē smooth does not get wet while travelling, and do not use 3. elōs energy level has not it in a wet environment. been selected.
If the product should become defective within the warranty period, please contact your local retailer or go to The nameplate label is adhered to the bottom of your mē smooth. It displays the www.mepower.com for further assistance or call us 0203 302 0606.
Page 12
Specifications Acceptable environmental conditions • Light spectrum: 550 – 1200 nm • Max Optical: 4J/cm2 Storage and transportation RF Wave frequency: 6.78 MHz • Temperature 14ºF- 131ºF (-10ºC - 55ºC) • Max Radiofrequency power: 5 Watts • Pulse Light repetition rate: up to 1.1 Hz (1 pulse every 0.9 seconds). Humidity 90% at 131ºF (55ºC) Electrical Rating: 100-240 VAC, 50-60 Hz...
Treating with the epilator cartridge Treating with the precision adaptor The mē smooth can be used with the epilator cartridge to prepare the skin body The device can be used with the precision adaptor when treating smaller areas at the same time or used alone.
Need help?
Do you have a question about the Smooth and is the answer not in the manual?
Questions and answers