Advertisement
Notice for Use
Thank you for choosing Eleaf products! Please read this manual carefully before use so
as to use correctly. If you require additional information or have questions about the
product or its use, please consult your local agents, or visit our website at
www.eleafworld.com.
Product Introduction
iStick 30W is an upgraded version compared with the original iStick. It is more
powerful: with 2200mAh battery capacity, it can handle up to 8V, 30W and support
sub ohm coil. It is more practical: wear-resistant stainless steel thread, elastic
connector and streamlined design on top make iStick 30W more suitable for
atomizers. More ever, the added button lock functionality protects the button from
unintentional presses. iStick 30W is the one you deserve to own.
How to use
Press the square button for five times to turn on the battery, and then long press the
square button to get a puff. Loosen the square button to stop puff.
up arrow button
down arrow button
Switch the VV/VW mode: Press the square button for three times to switch the VV/VW
mode when the battery is turned on. In VV mode, you can adjust output voltage between
2.0V-8.0V. In VW mode, you can adjust output wattage between 5W-30W.
Adjust the voltage/wattage: Press the up-and-down arrow buttons to increase or
decrease the voltage/wattage. Keep pressing the up/down arrow button, voltage/wattage
will increase or decrease slowly at first, then they will increase/decrease at a constant
high speed. The number will stop increasing/decreasing when you loosen the up/down
arrow button.
Button lock functionality: Keep pressing up-arrow button and down-arrow button
simultaneously for 2 seconds when the battery is on, then they will be locked and the
screen will reflect "Lock". Still keep pressing simultaneously for 2 seconds to unlock them
and the screen will reflect "Unlock".Through these operations, you can protect the buttons
from unintentional presses and prolong their service life.
Switch the display mode: Keep pressing up-arrow button and down-arrow button
simultaneously for 2 seconds when the battery is off, the screen display will rotate 180
degrees. You can view the screen from two kinds of angle through this operation.
How to charge
iStick 30 W is charged through USB port at the bottom of battery. It will take 2.5 hours to
fully charge the battery via 1A wall adaptor.
the OLED screen
iStick 30W
User Manual
the square button
Advertisement
Table of Contents
Related Manuals for Eleaf iStick 30W
Summary of Contents for Eleaf iStick 30W
-
Page 1: How To Charge
Product Introduction iStick 30W is an upgraded version compared with the original iStick. It is more powerful: with 2200mAh battery capacity, it can handle up to 8V, 30W and support sub ohm coil. It is more practical: wear-resistant stainless steel thread, elastic connector and streamlined design on top make iStick 30W more suitable for atomizers. -
Page 2: Properties
On the bottom of battery, there is a laser marker named “CE” . Precautions a) Only have your iStick 30W repaired by Eleaf. Do not attempt to repair the unit by yourself as damage or personal injury may occur. b) Do not leave the iStick 30W in high temperatures or damp conditions, otherwise it may be damaged.
Need help?
Do you have a question about the iStick 30W and is the answer not in the manual?
Questions and answers
How do I increase the wattage? If I push the arrow up button the istick switches off.
My istick 30 w shows a weird signal I’ve never seen before. When I charge it it shows this weird signal and no longer shows it charging