Eleaf MELO 2 User Manual

Notice for Use
Thank you for choosing Eleaf products! Please read this manual carefully
before use so as to use correctly. If you require additional information or have
questions about the product or its use, please consult your local agents, or visit
our website at www.eleafworld.com.
Product Introduction
With large liquid capacity of 4.5ml, the new MELO 2 atomizer is remarkably
simple and convenient to use, mainly featuring the side e-liquid fill hole for
ease of refilling e-liquid. When using with EC TC-Ni/EC TC-Ti head, the
MELO 2 atomizer can be compatible with various temperature control
devices.

How to assemble

1. First screw the atomizer head onto the atomizer base tightly;
2. Next screw the atomizer tube onto the atomizer base tightly;
3. Then put the atomizer base and atomizer tube together with the
mouthpiece;
4. Finally screw the MELO 2 atomizer onto battery.
Air-inlet Hole Airflow Control Ring
Atomizer Base

How to add liquid

The e-liquid fill hole is located in the side of the top cap of atomizer tube.
Rotate counterclockwise the regulation ring on the top cap to open the
e-liquid fill hole. Then slowly refill e-liquid into the glass tube. Finally close
the e-liquid fill hole by rotating clockwise the regulation ring.
Note: 1. Please first drip a few drops of e-liquid directly into the pure cotton
wick in the atomizer head so as to make it fully soaked before
vaping.
MELO 2 Atomizer
EC Head Glass Tube
User Manual
Atomizer Tube Side E-liquid Fill Hole
Air Pipe
Side E-liquid Fill Hole
Mouthpiece