16. Do not unplug by pulling on the cable. To unplug, grasp the plug, not the cable. 5. Use only as described in this Dyson Operating Manual. Do not carry out any maintenance 17. Do not stretch the cable or place the other than that shown in this manual, or cable under strain.
23. When refilling, only do so as described in this automatic cut-out switches that operate if it tips over. If the switches operate, unplug the Dyson operating manual. Do not use hot water. appliance. Before restarting, check and clear 24. Always place the appliance on a firm, flat, any blockages, allow to dry and ensure the level surface.
Register by mail Alternatively, visit www.dyson.co.uk/support (UK) or www.dyson.ie/ Complete and return the form to Dyson in the envelope supplied. support (ROI) for online help, general tips and useful information about Dyson. Dyson contact details UK: Website: www.dyson.co.uk/support...
Getting started For the best performance place humidifier on the floor in the corner of the room, facing into the centre. It should be at least 1m from any wall. To avoid a cooling effect while humidifying, the unit should be at least 1m from any people.
Page 7
Plug into the socket and base. A small Switch ‘ON’. The water treatment After 3 minutes the appliance will start blue LED on the back of the appliance procedure automatically starts. to humidify. The display will show the lights up to confirm that the appliance Water passes over a UV-C emitter to target humidity setting.
How to use Fan/ humidity toggle ON/ OFF switches between humidifier and fan modes. Control with airflow and timer buttons. On/off Controlling the humidity manually Airflow Increase airflow. Increase target humidity. 1 to 10 30 to 70% Decrease airflow. Decrease target humidity. 10 to 1 70 to 30% The appliance will not mist...
Blue light indicates that the AM10 is in humidity mode. White light indicates that the AM10 is in fan mode. Switch ‘ON’: the water treatment procedure starts. After 3 minutes the appliance will start to humidify.
Cleaning – important! Cleaning procedures must be routinely followed to ensure that the humidifier continues to operate efficiently. Cleaning regimes are designed to help prevent the build up of scale within the machine, which will be more prominent in hard water areas. Failure to adhere to the cleaning regimes may invalidate the warranty.
Once a week Wipe over air loop amplifier, paying Turn the appliance into standby mode/‘OFF’. close attention to the air gaps. Wipe with a lint-free microfibre cloth. Unplug from the mains electricity supply. Empty the water. Rinse and wipe over all surfaces.
Once a month (and before/after storage) Unclip the loop amplifier surround: pull from the lower Turn the appliance into standby mode/‘OFF’. Unplug from the mains electricity supply. edge by hand, gently but firmly. 15 mins Empty the water tank. To release the water chimney, twist the dial a quarter of a turn.
Page 13
Some cleaning chemicals are harmful to the appliance and should not be used. Use of these will invalidate your guarantee. Do not use: Alcohol and strong acid mixes, solvent (acetone) and oil based products, alkali bleach mixes, air fresheners, aroma oils, scented oils, hot water, brushes, abrasive materials, etc.
What do the lights mean? Water treatment The AM10 is treating the water. This takes 3 minutes. When the animation stops, the AM10 will start to humidify. Tank is empty Switch ‘OFF’ and refill. Tilted The base is not level.
Using your humidifier Please read the ‘Important Safety Instructions’ in this Dyson Operating appliance will switch itself ‘ON’ or ‘OFF’ as necessary to maintain Manual before proceeding. that level. The fan will remain running when the target humidity has been reached.
• Complete the enclosed form and post it to us. CAUTION This will confirm ownership of your Dyson appliance in the event of an • Unscrew the battery compartment on the remote control. Loosen insurance loss, and enable us to contact you if necessary.
Telephone Mobile As a Dyson fan owner, you can hear about Dyson We sometimes ask other companies (such as market researchers) to inventions, services and products before anyone else. contact owners on our behalf. We do this to get feedback on ideas or If it’s okay to contact you, please let us know how we...
Need help?
Do you have a question about the AM10 and is the answer not in the manual?
Questions and answers