Table of Contents
Advertisement
Available languages
Available languages
CLEANING AND PREVENTIVE
MAINTENANCE
PRECAUTION AND CLEANING
INSTRUCTIONS
-
IMPORTANT: Before carrying out the
cleaning and maintenance
disconnect the equipment from the
power supply:
-
high temperatures can be reached
the machine (90°C). After power supply has
been removed, wait until the machine has
reached the room temperature, before
working on it.
-
The machine protection degree
therefore it should not be
direct high pressure jets of water.
-
Never leave tools, parts or other loose
material on or in the machine.
-
Before starting machine or cycle, after any
maintenance or repair work, make sure all
protective are correctly installed.
POSSIBLE TROUBLES - CAUSES - SOLUTIONS
PROBLEMS CAUSES
The machine doesn't catch
The water doesn't go in
Insufficient Washing
Insufficient Rinsing
operations,
mains
inside
is IP21,
washed with
Main switch is switched off
Water cock closed,
The Overflow is not in its place
Wrong detergent or dosage
Insufficient,
Low temperature in the tank,
Dirty wash filter
Rinsing nozzles blocked,
Hydraulic pressure lower than
1 bar - 100 kPa
CAUTION! FOR ANY OTHER TROUBLE, CALL SERVICE
DAILY MAINTENANCE
-
Disconnect the machine with pushbutton
"A";
ATTENTION!!
-
Disconnect the machine from
power supply source by means of the
wall-mounted switch.
-
Lift the overflow pipe and let the water
drain out of the tank;
-
Wash thoroughly the tank and
housing to remove all the impurities;
-
Take the filters and clean them under
running water;
-
Re-assemble the overflow pipe and the
filters in their housings;
-
Check and clean the washing and the
rinsing jets;
-
Clean the outer surface of the machine by
using a wet sponge; don't use
because, besides being dangerous they
could damage the electrical parts;
use abrasive detergents;
-
When the machine is to remain idle for a
long time, drain all the water from
boiler and
Also leave the wash tank open.
NEVER WASH THE EXTERNAL
THE MACHINE WITH A WATER JET
SOLUTIONS
Turn ON the main switch
Open water cock,
Reassemble the Overflow in
place
Use anti-foam detergent in the
right dosage and never with
cold water,
Wait untill the water gets hot,
Clean the filter
Unscrew and clean nozzles
under running water,
Wait until the pressure is on or
buy a booster pump
13
the main
the filter
water jets
from the electropump.
PART
don't
the
OF
its
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the DSP4 and is the answer not in the manual?
Questions and answers
How to drain?
To drain the Lamber DSP4, ensure that the drain system is properly set up. The machine has a separate drain pump that can lift water up to 24 inches (61 cm) above the floor level. The drain connection is 32 mm (1"1/4 G). Make sure the drain hose is positioned correctly and that the drainage system is not blocked.
This answer is automatically generated
Cycle button F blinking.
When the cycle button is blinking on the Lamber DSP4, it indicates that the wash cycle has been interrupted. Pressing the button again will restart the cycle from where it was stopped.
This answer is automatically generated