User Operations; Recording - GE DSR-2000e User Manual

2
U
SER
2.1

Recording

To begin recording, press the Record button. RECORD will be indicated for
three seconds, near the upper left hand corner of the primary monitor. The
unit always starts recording at the end of the previously recorded data.
Recording will continue until:
•
Another mode is selected (Play mode, or Stop mode).
•
The disk is full (In No Overwrite and Overwrite Once modes).
See section 5.1 Advanced Menu → Disk Overwrite Mode on
page 5-1, for details regarding Disk Overwrite modes.
1. Current time.
2. Record time left until disk full.
3. Record Mode Indicated.
4. Normal Record Speed in Pictures Per Second. If the letter A precedes the record rate, the unit is
configured to record or playback audio.
Normal Recording
The unit records at the normal record speed until an alarm condition is detected.
The normal record speed is indicated on the LCD, and can be altered using the
Up/Down Record Speed buttons, or in the menu system.
For information about altering the normal record speed from the menu system, see
Main Menu → Record Settings → Normal Record Speed, on page 4-7 of the
Operator Programming section of this manual.
The normal record speed can be altered while the unit is recording. The unit will
continue recording while the menu system is active.
O
PERATIONS
Figure 2-1 LCD in Record mode
10:55:45A
1
1d12h
2
REC
3
A0.2p
4
RECORD
Record button
REC/PLAY
SPEED
Record Speed
buttons