Zte ZXHN H560N Quick Start Manual

Hide thumbs Also See for ZXHN H560N:

Package Contents: H560N Wireless Router, Quick Start Guide, Warranty Card

ZXHN H560N buttons show as follow.

Button/Switch

WPS

(Wi-Fi

Protected

Setup)

Reset

USB

AP/Extender

Figure 1-1 Connecting the Equipment

Direction

Users can easily push the WPS button for quick and safe WLAN configuration

with other WLAN devices.

Users can reset ZXHN H560N by pressing this button.

It can provide electrical current to charge your mobile device (Max 1A)

AP: Access Point (see figure 1-1, AP mode and router mode)

Ext: Extender (see figure 1-1, Extender mode 1 and 2)

- 1 -

Table of Contents

Need help?

Do you have a question about the ZXHN H560N and is the answer not in the manual?

Page 1: Connecting The Equipment
Protected with other WLAN devices. Setup) Reset Users can reset ZXHN H560N by pressing this button. It can provide electrical current to charge your mobile device (Max 1A) AP/Extender AP: Access Point (see figure 1-1, AP mode and router mode)
Page 2: Led Indicator
After connecting the H560N, please check the indicators. The description is in Part 3. LED indicator ZXHN H560N uses a 2-color LED, red and green, to indicate the status as follow. Color Description ON: The device is booting or hardware error.
Page 3: Connect As Bridge/Router Mode
Press the WPS buttons of H560N and hold it down around 0.5 seconds, the LED will Flash in Green with a 5Hz frequency. Press the WPS button of the existing router (Please refer to Figure1-1 ), Please note: the Existing Router’s setup has to be with No encryption and it’s SSID (network name) must be set to “visible”.
Page 4: Safety Precautions
Assign a fixed IP address, 192.168.1.x for your computer.(The default mode is bridge mode, H560N can’t assign IP address automatically) Open a browser and Input 192.168.1.253 to login to H560N. Use the Wizard to configure H560N. Change your computer back to DHCP. Safety Precautions ...