Controls & Features - Cub Cadet RZT Series Operator's Manual

Controls & Features
Throttle Control
or Throttle/Choke
Control
Choke Control
Hour Meter/
Indicator Panel
Seat Adjustment Lever
Fuel Tank Cap
Fuel Level Indicator
NOTE: This Operator's Manual covers several models. Tractor
features may vary by model. Not all features in this manual are
applicable to all tractor models and the tractor depicted may
differ from yours.
NOTE: References to LEFT, RIGHT, FRONT, and REAR indicate that
position on the tractor when facing forward while seated in the
operator's seat.
RH and LH Drive Control Levers
The RH and LH control levers are located on each side of the
operator's seat. These hinged levers pivot outward to open
space to permit the operator to either sit in the tractor seat, or to
dismount the tractor. The levers must be fully opened out and in
the neutral position to start the tractor engine.
Each lever controls the respective RH or LH transmission.
Consequently, these levers control all of the movements of the
tractor. Driving and steering utilizing these control levers is
quite different from conventional tractors, and will take some
practice to master. Refer to Operation for instructions on using
the control levers.
12
Deck Height
Parking Brake
Control Lever
Deck Lift
Handle
Index
LH Drive RH Drive
Control Lever
Figure 4-1
Deck Height Index
The deck height index consists of six index notches
located on the front/right of the seat box frame. Each
notch corresponds to a 1⁄2" change in the deck height
position ranging from 1-1⁄2" at the lowest notch to 4" at
the highest notch.
Deck Lift Handle
The deck lift handle is located on the front/right of
the seat box frame, and is used to raise and lower the
mower deck.
Pull the handle to the left out of the index notch and
push downward to lower the deck, or pull upward to
raise the deck. When the desired height is attained,
move the lift handle to the right until fully in the index
notch.
4
PTO Switch
Ignition Switch
Cup Holder
Storage Tray