Page 1
CONTENTS SPECIFICATIONS PANEL LAYOUT DIMENSIONS CIRCUIT BOARD LAYOUT DISASSEMBLY PROCEDURE IC BLOCK DIAGRAM IC CIRCUIT BOARDS INSPECTIONS TROUBLE SHOOTING PARTS LIST BLOCK DIAGRAM u163 CIRCUIT DIAGRAM 011775 20050321-86100 HAMAMATSU, JAPAN Copyright (c) Yamaha Corporation. All rights reserved. PDF-K9611 ’05.04 http://www.xiaoyu163.com...
Page 2
IMPORTANT NOTICE This manual has been provided for the use of authorized Yamaha Retailers and their service personnel. It has been assumed that basic service procedures inherent to the industry, and more specifically Yamaha Products, are already known and understood by the users, and have therefore not been restated.
STAGEPAS 300 3 7 63 1515 0 SPECIFICATIONS General Specifications Maximum Output Power 150 W+150 W/6 Ω @10 % THD at 1 kHz (SPEAKER L/R) 100 W+100 W/6 Ω @1 % THD at 1 kHz (SPEAKER L/R) Frequency Response -3 dB, 0 dB, +1 dB @20 Hz–20 kHz, 1 W Output/6 Ω...
Page 4
STAGEPAS 300 3 7 63 1515 0 PANEL LAYOUT q [POWER] switch w [AC IN] jack e [SPEAKER L/R] jacks r [REC OUT L/R] jacks t [MONITOR OUT L(MONO)/R] jacks y Channel input jacks (CH 1 to 4) u Stereo channel input jacks (CH 5/6, 7/8)
STAGEPAS 300 3 7 63 1515 0 DISASSEMBLY PROCEDURE Front Grille Assembly (Time required: About 1 minute) Remove the four (4) screws marked [120A]. The front grille assembly can then be removed. (Fig.1) Speaker LF (Woofer) (Time required: About 2 minutes) Remove the front grille assembly.
Page 8
STAGEPAS 300 3 7 63 1515 0 Mixer Assembly, Cover Mold Assembly (Time required: About 1 minute) Rotate the two (2) straight slots on the fastener heads with a coin driver or minus driver until each straight slot is in alignment with the OPEN position.
Page 9
STAGEPAS 300 3 7 63 1515 0 Mixer Assembly (Panel Assembly, Rear Case Assembly) (Time required: About 3 minutes) Remove the mixer assembly. (See procedure 6) Remove the eight (8) screws marked [340], and separate the panel assembly and rear case assembly from the mixer assembly.
Page 10
STAGEPAS 300 3 7 63 1515 0 VR Circuit Board (Time required: About 10 minutes) 10-1 Remove the INPUT circuit board. (See procedure 9) 10-2 Remove the six (6) volume knobs (white) marked [130] and the volume knob (red) marked [140] from the panel printing side.
Page 11
STAGEPAS 300 3 7 63 1515 0 [100B] Volume knob (S) (White) [120B] Volume knob (S) (Blue) (S)( )) (S)( )) [110A] Volume knob (S) (Green) X 12 (S)( )) [90] Push button X 5 Fig.11 ( FILTER Circuit Board...
STAGEPAS 300 3 7 63 1515 0 [260] X 7 [270A] POWER [270B] Power amplifier unit B Power amplifier unit A [CN5] [CN6] [CN4] [CN7] Rear case assembly [260]: Bind Head Tapping Screw-B ( ) 3.0X8 CR3 (AAX61980) [270]: Bind Head Tapping Screw-B ( ) 3.0X10 NI-BL (AAX61710)
Page 14
STAGEPAS 300 3 7 63 1515 0 Fan (Small) (Time required: About 7 minutes) 15-1 Remove the POWER circuit board. (See procedure 14) 15-2 Remove the shield case together with the fan (small). (Fig.20) 15-3 Remove the four (4) screws marked [110B]. The fan (small) can then be removed from the shield case.
STAGEPAS 300 3 7 63 1515 0 IC BLOCK DIAGRAM M65850FP (AAX62760) Digital Echo FILTER: IC602 CLOCK OP2 IN OP2 OUT LPF2 IN LPF2 OUT LPF2 OSCILLATOR D / A LPF1 IN 1/2 Vcc LPF1 OUT CLOCK CLOCK OP1 OUT...
Page 17
STAGEPAS 300 3 7 63 1515 0 NETWORK1 Circuit Board Component side Pattern side L 13942296513 407751, 407752 407750 NETWORK2 Circuit Board Component side u163 Component side Pattern side 407751, 407752 407750 http://www.xiaoyu163.com...
Page 18
STAGEPAS 300 3 7 63 1515 0 POWER Circuit Board L 13942296513 u163 Component side 407751, 407752 http://www.xiaoyu163.com...
Page 19
STAGEPAS 300 3 7 63 1515 0 POWER Circuit Board L 13942296513 u163 Pattern side 407750 http://www.xiaoyu163.com...
Page 20
STAGEPAS 300 3 7 63 1515 0 VR Circuit Board L 13942296513 u163 Component side 407747 http://www.xiaoyu163.com...
Page 21
STAGEPAS 300 3 7 63 1515 0 VR Circuit Board L 13942296513 Pattern side u163 407744 http://www.xiaoyu163.com...
Page 22
STAGEPAS 300 3 7 63 1515 0 FILTER Circuit Board Component side Pattern side 407747 407744 L 13942296513 JACK1A Circuit Board JACK1B Circuit Board JACK2 Circuit Board to NETWORK1-CN10 to NETWORK2-CN8 NETWORK2-CN8 NETWORK1-CN10 Component side Component side Component side...
Page 23
STAGEPAS 300 3 7 63 1515 0 INSPECTIONS Test Conditions Measuring Voitage AC 100 V 50/60 Hz (J) AC 120 V 60 Hz (U, C, V) AC 240 V 50 Hz (A) AC 230 V 50 Hz (B, H, W)
Page 25
STAGEPAS 300 3 7 63 1515 0 ITEM INPUT CONDITIONS OUTPUT CONDITIONS NOMINAL LIMIT CROSSTALK INPUT 1, 2, 3, 4, 5, 6, 7, 8 to SP OUT: 75 dB >70 dB Adjacent INPUT REF: 100 W OUTPUT SIGNAL TO NOISE...
Page 26
STAGEPAS 300 3 7 63 1515 0 TROUBLE SHOOTING ∗ Points marked by “ ” to “ ” in the figure of circuit board are the points to be checked as indicated by the same marks in the flowchart on the next page or after.
Page 27
STAGEPAS 300 3 7 63 1515 0 • Trouble Shooting (POWER circuit board) START [ No Load ] F1 (Fuse) < Fuse :Primary > OPEN ? CN4: 7 pin < Power Supply :+VB > +VB = +38 V (DC) CN4: 5 pin <...
Page 28
STAGEPAS 300 3 7 63 1515 0 < Power LED > Connect the circuit boards(INPUT,FILTER,VR)and two fans. < Signal Path > < FAN > Q822:ON Power LED = ON Remove the Power Amplifier Unit. CN9: 2 pin(4 pin) Power LED = ON...
http://www.xiaoyu163.com 3 7 63 1515 0 PARTS LIST CONTENTS OVERALL ASSEMBLY ..........2 MIXER ASSEMBLY ........5 REAR CASE ASSEMBLY ......7 L 13942296513 ELECTRICAL PARTS ......... 8-20 Notes : DESTINATION ABBREVIATIONS A : Australian model M : South African model B : British model O : Chinese model C : Canadian model...
Page 35
STAGEPAS 300 3 7 63 1515 0 REAR CASE ASSEMBLY L 13942296513 100a 1) The screws are for transportations only. Remove the screws during assembly. PART NO. DESCRIPTION REMARKS REF NO. QTY RANK REAR CASE ASSEMBLY STAGEPAS 300 Rear Case Assembly...
Need help?
Do you have a question about the STAGEPAS 300 and is the answer not in the manual?
Questions and answers