Page 1
® Pressure Side Pool Cleaner Installation Guide IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS SAVE THESE INSTRUCTIONS LEGEND® INSTALLATION MANUAL...
Page 2
10951 West Los Angeles Ave., Moorpark, CA 93021 • (805) 553-5000 Trademarks and Disclaimers. The Pentair Water Pool and Spa logo is a trademark of Pentair Water Pool and Spa, Inc. The Legend logo is a registered trademark of Pentair Water Pool and Spa, Inc. Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products.
Page 3
1-1/2" line, dedicated to our Universal Booster Pump. Also, if you have a chlorinator, solar system or other air inducing equipment, please contact our Technical Support Department at 1-800-831-7133, before you install the Legend ®...
TABLE OF CONTENTS I. Introduction ..........................1 ® A. Thank You for Choosing the Legend ........................... ® B. What to Expect from the Legend ............................II. Installation Instructions ......................2 A. Legend ® Components ....................... 2 B. Pool Connections ......................2 C.
® the Legend will go into a back up mode. At this limited warranty that protects against defects in parts time the Back Up Valve will pull the Legend® away and construction. from problem areas. ® Like any mechanical device, the Legend...
Please follow these instructions carefully. The booster pump is not self-priming and needs to be fed with water taken from the pool filter before any type of in-line chlorinator. See figure below. LEGEND® INSTALLATION MANUAL...
(soft) hose. Wall Fitting with ease from the Wall Adapter. Telepole / Clear (Soft) Hose Measure and Mark the Water Level Deepest End of Pool Main Drain LEGEND® INSTALLATION MANUAL...
Page 8
(CLEANER SIDE) FIGURE 1 WHITE OR GREY MARKED SWIVEL HARD HOSE SECTION SOFT HOSE END OF (Cut to your pool depth) SOFT HOSE (End remains 30 in.) BACK UP VALVE FURTHEST POINT OF POOL PERIMETER FROM WALL FITTING LEGEND® INSTALLATION MANUAL...
Page 9
Marked Swivel. (Example: Half of 6 ft. = 3 ft. each). If you are cutting more than 2 ft. off the hoses, remove the floats next to the Marked Swivel from both hoses. See figures on page LEGEND® INSTALLATION MANUAL...
Page 10
Be sure to slide the floats out of pool carefully. It should look like figure below. the way when cutting hose. 9. Put extra mender nut on the Legend ® mast and FIRST...
® The Legend comes with a Twist Lock Pressure Relief Valve (Wall Fitting). If the Legend ® is receiving G. Fine Tuning the Legend ® too much water pressure, the Relief Valve in the Wall Fitting will release the excess water pressure.
Mark the front drive Tire/Wheel with a marker, or use the Pentair logo located on the side of tire as a marker to count the rotations of the wheel per minute. If you have any additional questions, Have someone turn on pool pump and the booster please contact Pentair Pool Products Inc.,...
The Legend operates off the booster pump coming ® passed by the pool filter out of the Legend . Running from the equipment pad, and can be turned on or off the Cleaner without the filter screen can damage the...
The Wheel Bearings are warranted free of defects 6. Debris Valve when shipped from Pentair Water Pool and Spa, Inc., and are considered a wear item. A good bearing will This valve is located under the Debris Bag, it is spin freely.
Legend and adjust to the appropriate height. (Part # for Step Adapter is EU13) ® 4. New Legend suction Cup Tires Designed to climb in problem areas, fiberglass, tile and smooth surfaces. For other applications, please contact our Technical Service Department at 1-800-831-7133.
Legend ® doesn't move or moves sluggishly or hangs ® A Reminder: The climbing ability of the Legend is dependent on up on steps. the pool's shape and available water pressure. It will climb better in pools without sharp angles or curves in the transition from the Solution: 1.
Need help?
Do you have a question about the LEGEND and is the answer not in the manual?
Questions and answers