Rainbow Pool Products PO Box 2388, Mansfield Qld 4122 Telephone STD 61-7-3849 5385 Facsimile STD 61-7-3849 5384 Email: info@rainbowpoolproducts.com.au Web: www.rainbowpoolproducts.com.au Pressure Side Pool Cleaner Installation and User’s Guide IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS SAVE THESE INSTRUCTIONS LEGEND INSTALLATION MANUAL ®...
Page 2
® trademarks of Pentair Water Pool and Spa, Inc. and/or its affiliated companies in the United States and/or other countries. Unless noted, names and brands of others that may be used in this document are not used to indicate an affiliation or endorsement between the proprietors of these names and brands and Pentair Water Pool and Spa, Inc.
IMPORTANT WARNING AND SAFETY INSTRUCTIONS Important Notice: Attention Installer: This guide contains important information about the installation, operation and safe use of this product. This information should be given to the owner and/or operator of this equipment after installation of the pool cleaner.
LL505G LL505GG Important Information: The Legend automatic pool cleaner comes ready to connect into a female threaded 1-1/2" (38mm) line, ® dedicated to our Universal Booster Pump. Also, if you have a chlorinator, solar system or other air inducing equipment, please contact our Technical Support Department at 1-800-831-7133 [USA] or {Herentals –...
TABLE OF CONTENTS Important Safety ..................3 Disclaimer of Liability ......................... 4 Important Information ......................... 5 I. Introduction ........................... 7 A. Thank You for Choosing the Legend ..................7 ® B. What to Expect from the Legend ..................... 7 ® II.
I. Introduction A. Thank You for Choosing the Legend Pool Cleaner ® Congratulations on the purchase of your new automatic pool cleaner. The Legend is designed to give ® you years of dependable and efficient service. With the Legend , you and your family will spend more ®...
II. Installation Instructions A. Legend Components ® The Legend Box Contains: ® 1. Cleaner Head 2. Sand & Silt Bag 3. Sweep Hose (Attached to Cleaner Head) 4. Complete Feed Hose a. 1 - 8½” (22 cm) hose 2 - 10’ (3 m) white (hard) hoses c.
D. Installing the Twist Lock Pressure Relief Valve (Wall Fitting) 1. Take out any existing pool cleaner and/or wall WALL ADAPTER fitting. INSTALLED 2. Turn on the filtration pump and booster pump, QUICK DISCONNECT flush out the plumbing line. 3. Turn off filter pump and booster pump. 4.
Page 10
EXAMPLE OF HOSE ASSEMBLY STEPS BEFORE CUTTING TO LENGTH 1. With the feed hose assembly attached to the pool wall, hold the feed hose assembly by the opposite end with the soft hose and walk the perimeter of the pool to locate the farthest point on the perimeter from the wall fitting without stretching the hose assembly.
Page 11
E. Cutting the Feed Hose - (cont.) 3. Lay the telepole next to the soft hose. If the clear soft hose is Telepole / Soft Hose longer than the mark on the telepole, cut the excess from the Water Level end attached to the white (hard) White (Hard) Hoses Swivel...
Page 12
E. Cutting the Feed Hose - (cont.) 8. When cutting hoses, please use strong scissors or a sharp knife. Be sure to slide the floats out of FEED HOSE the way when cutting hose. 9. Put extra mender nut on the Legend mast and MENDER NUT ®...
F. Checking Operation When operating correctly, the Legend will travel in a random pattern throughout the pool, vacuuming ® and sweeping the bottom. The climbing ability of the Legend is dependent on the pools structure and ® water flow coming into the pool. It will perform more efficiently in pools without sharp angles or curves in the transition from the floor of the pool to the wall.
If the RPM is more than 32, at the Wall Fitting, unscrew the Pressure Relief Valve slowly until the RPM falls between 28-32. If you have any additional questions, please contact Pentair Water Pool and Spa, Inc., Technical Support Department at:1-800-831-7133 [USA] or {Herentals – Belgium +32 (0) 14.25.99.11}, Monday through Friday.
C. Cleaning the Sand & Silt Bag Carefully unlock the debris bag from the vacuum tube. Use "U" SHAPED your thumb to push the "U" shaped snap lock closure upward SNAP LOCK OPEN Push middle of CLOSURE until it snaps open. Make sure to swing it away from the the bag inward for closure.
The Wheel Bearings are warranted free of defects when shipped from Pentair Water Pool and Spa, Inc., and are considered a wear item. A good bearing will spin freely.
G. Accessories 1. Sweep Hose Weight If the sweep hose tends to break the surface of the water therefore squirting nearby windows or innocent bystanders, a weight can be installed to the end of the sweep hose. (Part # for Hose Weight is EH09C) 2.
IV. TROUBLESHOOTING AND PERFORMANCE TIPS To insure the best performance from your cleaner, follow the troubleshooting guide listed below. Problem Solution Legend doesn't move or moves 1. Be sure filter pump and booster pump are on and working properly. (You may need ®...
Need help?
Do you have a question about the Legend LL505G and is the answer not in the manual?
Questions and answers