Installing The Usb Driver - Digital Check CheXpress CX30 User Manual

Installing the USB driver

NOTE: Confirm that the TellerScan USB Device drivers have been installed before
connecting the USB cable to the PC. If you have not installed or received the
device drivers, contact your check scanning solution provider.
Optional driver installation directions/using the DCC demo programs:
TellerScan USB Driver
1) Download the
http://www.digitalcheck.com/integration_support/drivers_and_demo_programs
2) Unzip the file and run the driver utility program to automatically install the firmware
and create a folder for the driver files (C:\Program Files\TellerScan\Drivers).
3) Connect the power supply and the USB Cable. The LED on the scanner control
panel should now be showing 'red'.
4) Windows detects a new hardware device.
5) The LED will turn 'green' when the application launches and acquires the scanner.
NOTE: While the scanner will run on a USB 1.1 port, it is recommended that a USB 2.0 port be
used to provide better overall performance. An INI file parameter will need to be increased to
allow running on a USB 1.1 port due to the slower throughput. Check with your application
provider.
Install the Demo Software Program
ScanLite program for testing the scanner and during the cleaning process)
To download ScanLite Go to:
http://www.digitalcheck.com/integration_support/drivers_and_demo_programs
The demo software is a basic scan program that allows you to operate the scanner,
change different scanner settings, view images, and store them on your PC's hard disk.
The demo program is not the software to run the system. Additional application software
is required. ScanLite is an easier demo program to use and is recommended that it be
used when cleaning the scanner.
1. Create a sub directory on the PC and label it "ScanLite."
2. Copy the ScanLite files into the directory.
3. Launch the ScanLite.exe to open the demo application.
file from the web site.
(Download from the Digital Check website. Use the
9