Remote Couplers Spillage Collector - Kubota M100GX Operator's Manual

82 HYDRAULIC UNIT
C Adjusting the flow rate
1. The flow rate for the remote control valves (1) and (2)
can be adjusted.
2. Turn the flow control
counterclockwise (A), and the flow rate for the remote
control valves (1) and/or (2) increases. A clockwise
turn (B) of the knob causes the flow to decrease. If the
knob is turned all the way (C), there will be no flow.
3. To adjust the flow rate, set the engine speed to the
operating RPM, turn the flow control knob once all the
way clockwise (C), and then turn it gradually
counterclockwise until a required flow rate is reached.
A Oil from the pump flows by priority to the auxiliary
control valve. Surplus oil is fed to the 3-point hitch.
With the auxiliary control valve at neutral, the total flow
from the pump is fed to the 3-point hitch.
A When there is no need to adjust the flow rate, turn the
flow control knob all the way counterclockwise and
keep it in this position.
(1) Remote control valve with flow control
(2) Remote control valve with flow control
(3) Flow control knob for valve (1)
(4) Flow control knob for valve (2)
knobs (3) and/or (4)
(A) "INCREASE"
(B) "DECREASE"
(C) "STOP"
BRemote Couplers Spillage Collector
With the remote control valve coupler in place, a slight
amount of oil leaking from the coupler is recovered. In this
way, no oil is splashed around the tractor body.
(1) Collector cap
(2) Oil tank
A Oil recovered contains dust and water. Do not pour
such oil back into the transmission case.