Fujitsu ETERNUS DX100 S3 Setup Manual page 75

Chapter 5 Host Interface Management
5.2 Modify Port Parameters
The main setting items are as follows.
●
Port Settings
• Port
• Connection
• Set Loop ID
• Loop ID
• Transfer Rate
• WWN (Port Name)
• WWN (Node Name)
3
Click the [Modify] button.
 A confirmation screen appears.
If the Loop ID is changed while a server is operating, reboot the server immediately. If the server is
operated without being rebooted, a warning message may appear or a system failure may occur.
4
Click the [OK] button.
 Setting of the FC port parameters starts.
5
Click the [Done] button to return to the [FC Port] screen.
FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)
Copyright 2014 FUJITSU LIMITED
75
End of procedure
P2X0-1250-06ENZ0