Step By Step Basics; Turn The Power On - Yamaha Pocket Miku User Manual

Step by step basics

1. Turn the power on

1. Turn the power on
There are 2 ways to power your Pocket Miku, either by using regular batteries or by using a USB power source.
 Using batteries to power your device
Open the back cover, and place 3 AAA alkaline batteries in the
correct + and - positions. Put the power switch in the [BATTERY]
position. The LED will light up along with a voice announcing that
your device is on.
 Using a USB cable to power your device
* A USB cable is not included with this product. Please purchase one at an
electronics retailer.
Connect the Micro-B type connector end of the USB cable (the end
you would plug into a smart phone) into the USB port on the top
edge of the device. Connect the other end, the A type connector,
into the device that will serve as your power supply.
Put the power switch in the [USB] position. The LED will light up
along with a voice announcing that your device is on.
* Even if your device is plugged in via USB, if your switch is turned
to [BATTERY], the device will use your batteries as a power source,
depleting them in the process.
* Even if batteries are installed in your device, if your switch is turned to
[USB] and your device is not plugged in via USB, the power will remain
off.
Entering and exiting stand by mode (power saving mode)
When the power switch is turned to [BATTERY] and the power is
on, after 5 minutes of no activity the device will enter stand by
mode and the LED will begin to flash at one-second intervals.
* When a USB cable is plugged into the device, stand by mode will
not be activated, regardless of the position of your power switch.
* In stand by mode, the device's electricity consumption will be
reduced to a fifth of the usual level (from about 100mA to 20mA).
The device will continue to consume battery power, although at a
slower rate. Please turn off your device when you will not use it for
a long period of time.
To exit stand by mode and return the device to normal operation, press any of the buttons on the front of the
device or touch the carbon keyboard with the stylus.
* When exiting stand by mode, the device's response to the use of the button or the stylus may lag slightly.
7