Table of Contents
Advertisement
Troubleshooting
Problem
Machine will not produce
haze when control panel or
remote control HAZE switch
turned on
Machine can be fired from
control panel or remote
control, but not by DMX
controller
Haze output is weak
Wet, greasy, non-uniform
haze output, fluid drips or
spits from nozzle, or very
loud noise when firing
machine
Machine appears dead
Probable cause(s)
Machine not at operating
temperature
set to 0
set to 0
DMX signal present
DMX address setting
incorrect
Poor connection in DMX line
Machine requires priming
Incompatible haze fluid
Mains fuse blown
No power at AC cable inlet
Troubleshooting
Suggested remedy
Wait 5 to 7 minutes
Increase setting
Increase setting
Disconnect or turn off DMX
controller
Change DMX address (page
13)
Check DMX cables and
connections
Prime machine (page 13)
Use approved fluid!
Replace fuse (page 18)
Check power cable and
circuit breaker
19
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the JEM K1 Hazer and is the answer not in the manual?
Questions and answers