Page 1
If the buyer is not prepared to accept this liability, it can be returned new and unused to the place of purchase for a refund. Neither your dealer nor Thunder Tiger Distributors, can accept kits for return if construction has begun.
Page 2
AS6593 Canopy going to lift for those who are eager for the thrill of soaring. Standard equips efficient outrunner OBL29/09- 07A and performance folding prop that make eHawk 1500 an outstanding 1.5M EP glider in the market. Fuselage (1) 2X5 mm...
Page 3
WING TAIL 4. Join two wing halves with carbon joiner installed. Apply 1. Remove aileron then center all CA hinges in place. 7. Install the blind nut on the wing mounts as shown. 10. Secure the servo with the grommet, eyelets and wood screws which come with the servo as photo shown.
Page 4
Locate the servo horn, insert the Z-bend end at the Adjust the clevis and snap on the elevator control horn. Secure the motor ( recommend Thunder Tiger next secure the tail on the tail mount with mounting strip second hole. Trim away the excess portion of the servo OBL29/09-07A) with 3x5mm screw.
Page 5
3/8",9mm Elevator/Rudder-High Rate Flying eHawk 1500 Install the spinner with 2x6mm self-tapping screw 30. Trim the canopy alone with the molded line. Cut away as shown. the air inlet for cooling.
It takes lots of practice and concentration to thermal your eHawk 1500 for a glide. At altitude cut the motor soar like the Hawks and Eagles. Since the pilot is not and start your glide.
Need help?
Do you have a question about the eHawk 1500 and is the answer not in the manual?
Questions and answers