Radio - Panasonic CQ-C8400 Operating Instructions Manual

E

Radio

N
G
L
I
S
H
7
[SOURCE] [D·M] (Direct Memory)
1
Radio Mode
Press [SOURCE] to select the radio mode.
Radio mode display
Band Frequency
2
Band
Press [BAND].
FM1 FM2 FM3 AM
3
Tuning
[$]: Higher frequency
[%]: Lower frequency
Press and hold [%] or [$] for more than
0.5 seconds, then release. Seeking will start.
Note:
≥ When pressing [MENU] (pressing and hold
[MENU] for more than 2 seconds on the remote
control unit) in radio mode, the following display
appears.
This is because radio
mode does not have
any menu settings.
26
CQ-C8400/8300/8200/8100U
Stereo indicator [%] [$] ["] [#]
(TUNE) (Preset station)
[BAND]
(APM: Auto Preset Memory)
Direct Memory (D·M)
This is a useful function that can call broadcast
stations directly during playback in other modes (CD,
CD Changer, etc.), even when the power is off.
Your favorite radio station can be memorized in
[D·M] (direct memory).
Default: FM 87.9 MHz
∫ Memorize
1 Select a band and frequency.
2 Press and hold [D·M] for more than
2 seconds.
≥ Frequency blinks once and is saved in the
memory.
Note:
≥ New stations overwrite existing saved
stations after this procedure above.
∫ Recalling the Direct Memory
Press [D·M].
Direct Memory mode
Press [D·M] again to cancel.
POWER MENU
[SOURCE]
SOURCE SEL
NUMBER VOL
#
MUTE
1 2 3
[1] to [6]
RAND SCAN REP
4 5 6
(Preset station)
["] [#]
7 8 9
(Preset station)
[BAND] 0
BAND DISP
[%] [$]
SET
(Auto Preset
(Tuning)
Memory) Car Audio
Station Preset
Up to 6 stations can be stored in each of the FM1, FM2, FM3 and AM band selections.
Auto Preset Memory (APM)
Automatically save stations with good reception in
the preset memory.
1 Select a band (previous page).
2 Press and hold [BAND] (APM: Auto Preset
Memory) for more than 2 seconds.
≥ The 6 stations with good reception will be
automatically saved in the memory under
preset number 1 to 6.
≥ Once set, the preset stations are sequentially
scanned for 5 seconds each (scanning).
Note:
≥ New stations overwrite existing saved stations after this procedure.
Preset Station Calling
1 Select a band (previous page).
2 Press ["] or [#].
Press [1] to [6].
Caution:
≥ To ensure safety, never attempt to preset
stations while you are driving.
Manual Preset Memory
Manually save a station in the preset memory.
1 Select a band and frequency (previous page).
2 Press and hold ["] or [#] until the preset
number blinks.
3 Press ["] or [#] to select the preset number
(1 to 6).
4 Press and hold ["] or [#] for more than
2 seconds to memorize.
≥ The display blinks once, and a receiving station
is saved in the memory.
1 Select a band and frequency
(previous page).
2 Press and hold [1] to [6] for more than
2 seconds to memorize.
CQ-C8400/8300/8200/8100U
E
N
G
L
I
S
H
8
27