Installing The Smartcard-Reader Board; Removing The Ush Board - Dell Latitude E5450 Owner's Manual

Installing the SmartCard-Reader Board

1. Place the SmartCard-reader board into its slot on the palmrest.
2. Tighten the screws to secure the SmartCard-reader board to the palmrest.
3. Fix the SmartCard-reader cable and connect the SmartCard-reader cable to its connector on the
USH board.
4. Install the:
a. palmrest
b. keyboard
c. keyboard trim
d. battery
e. base cover
5. Follow the procedures in

Removing the USH Board

1. Follow the procedures in
2. Remove the:
a. base cover
b. battery
c. hard-drive assembly
d. keyboard trim
e. keyboard
f. palmrest
3. Perform the following steps to remove the USH board:
a. Disconnect all the cables from the USH board [1] [2].
b. Remove the screw that secures the USH board to the palmrest [3].
c. Remove the USH board from the palmrest [4].
After Working Inside Your
Before Working Inside Your
Computer.
Computer.
19