Panasonic CF-17 Operating Instructions Manual page 10

First-time Operation
5
7
8
2
1
Power
Indicator
Power Switch
10
Slide the battery pack inward until it is firmly in place.
5
CAUTION
Be sure the battery pack is properly connected to the connector.
The cover is closed by inserting the hook at the right end (see illustration) into
6
the groove.
7 Close the cover using the arrow as a guide.
8 Lock the latch into place.
CAUTION
Confirm that the latch lock is correctly in place. Should you decide to carry
6
your computer without the latch lock in place, the cover may open causing the
battery pack to fall out.
4
Connect your computer to a power outlet
CAUTION
Be sure the AC adapter is connected until completing Step 6 on page 11.
Handling the AC adapter
Do not twist or pull the AC power cord forcefully. Doing so may damage the
connections.
Use only the specified AC adapter with your computer. Using an AC adapter
other than the one supplied might damage the battery and/or the computer.
When the DC plug is not connected to the computer, disconnect the AC cord
3
from your AC wall outlet.
Problems such as sudden voltage drops may arise during periods of thunder and
lightning. Since this could adversely affect your computer, an uninterruptible
power source (UPS) is highly recommended unless the battery pack is installed.
5
Turn your computer on
Slide the power switch and hold it for approximately one second until the power
indicator ( ) turns on before releasing it.
CAUTION
After confirming that the power indicator has turned on, do not touch the
power switch until Windows setup has started.
Once the computer is powered off, you must wait at least ten seconds before
powering it on again.
NOTE
The power saving function is factory set, so if there is no input from a key, the
touch pad, or the external mouse for two minutes, the LCD is powered off (ECO
mode
In the ECO mode the LCD will resume operation when the touch pad is used, or
when a key or the touchscreen is pressed.
The computer may enter the ECO mode while Windows is setting up or even
when an application software is being installed. In this case, because it is con-
ceivable that a selection dialog box will be shown, for resuming from the ECO
mode, do not press Enter which may trigger a selection, instead, press a key
unrelated to the direct triggering of a selection, like
"Computing on the Road" )*.
* This excludes a pointing device connected to the USB port, e.g., a USB mouse.
Ctrl
key.