Table of Contents
Advertisement
Induction Cooking Zones
Cooktop Display Windows
The range backguard provides a digital window for each of the
cooking zones located on the cooktop. Power levels and
messages are easily monitored and controlled using the window
displays in combination with the corresponding control knobs.
Available Power Level Settings
The cooktop control
(Figure
10) will display power levels ranging
from Pb
(Figure
11), Hi
(Figure
15) to Lo
(Figure
12).
The settings between 9.5
(Figure
16) and 1.5
(Figure
17) decrease
and increase in 0.5 increments.
Figure 10: Cooktop control knobs
Use
Table 1
to determine the correct power level setting for the
type of food you are preparing.
Power Boost Power Level (Pb)
When setting an induction cooking zone for the highest setting
(to the POWER BOOST position), the display will initially show
Pb (Power Boost) power level for up to 10 minutes. After 10
minutes, the cooking zone will automatically return to the Hi
setting
(Figure
15). The Pb setting is only available immediately
Figure 15: High setting
Figure 11: Power Boost
after activating a cooking zone by turning the knob to the
highest setting (to the POWER BOOST position).
Hot Surface Window Message (HE)
After using an induction cooking zone, the cooktop may become
very hot. After turning any cooking zone off, the cooktop may
remain hot for some time. The corresponding Hot Element (HE)
message will remain on until the cooktop has cooled
(Figure
14).
ESEC Error Indicator Message (Er)
Figure 16: Increment setting
Figure 12: Low setting
An error message will be displayed (flashing Er)
(Figure
13) at
power up (or after a power failure) if any of the surface control
knobs were left in the ON positions. If a power failure should
occur, be sure to set all of the four surface control knobs to the
OFF position. This will reset the surface controls.
Be sure to reset the clock by referring to the
"Setting Clock"
heading on
page
19. Once the surface controls have been set to
the OFF positions and the clock has been set with the correct
time of day, the surface controls should return to normal opera-
tion. If the surface controls do not function and the Er message
Figure 17: Increment setting
Figure 13: Error message
remains in any display after following these procedures, contact
an authorized servicer for assistance.
Lockout Window Message (- -)
The (- -) message will appear whenever the Lockout, Self-clean
or Sabbath feature is active
(Figure
18). Refer to the
"Setting
Oven Lockout"
heading on
page 21
for more details.
Important:
The induction cooking zones will not operate when the oven is
Figure 18: Cooktop lockout
Figure 14: Hot element
set for Sabbath mode. For more details on the Sabbath feature,
indicator
indicator
see the
"Setting the Sabbath Feature"
on
page
28.
14
Hide quick links:
Advertisement
Table of Contents
