Setting The Tv To The Rf-Channel - Toshiba SD26VCR User Manual

Setting the TV to the RF-Channel

We recommend that television and DVD/VCR are being connected with a scart cable.
In this case, the setting of RF-channel is not necessary. Picture and sound of video cassette will be transmitted to
television through the scart cable automatically. Please read the next page.
In case of no scart cable connection,
you must set the television to the RF-
channel. Pay attention to the following
notice:
A built-in TV-broadcast in DVD/VCR can
do the video playback through the sup-
plied antenna cable. This broadcast is
sent on UHF, channel 60. To receive this
broadcast, you must tune your televi-
sion to channel 60 in UHF-band. (see
step 2)
In case a broadcast has already sent
to channel 60 in your area or you con-
nect an additional equipment (e.g. Sat-
ellite receiver) with a coaxial cable
(without a scart cable), you must tune
the sending channel in DVD/VCR (see
step 3). In your television store the both
equipment (the DVD/VCR and the sat-
ellite receiver) to 2 different program
positions.
Example: Your satellite receiver is sent
to channel 60. You tune the DVD/VCR
to channel 64 (see step 3).
(If your DVD/VCR is also sent to chan-
nel 60, interference will occur.)
In your television store the channel 60
to e.g. program position 3 and store the
channel 64 to e.g. program position 4.
Note that the program position 4 must
be suitable for video-playback espe-
cially. Please see the owner's manual
for your television. If the playback pic-
ture is often distored, you must select
the other program position for DVD/
VCR.
Note:
If you receive one TV-program on channel 59, 60 or 61, the interference can be occurred to the built-in TV channel
in DVD/VCR. If you use a scart cable for the transmission of picture and sound, you can cut off the built-in TV-
program. Then the video playback through the supplied antenna cable is not possible any more. Press CHANNEL
repeatedly (at step 1) until OFF will appear.(OFF appears after 69 or before 23)
14
Preparation
• Turn on the TV.
• Press VCR to select the VCR mode.
• Make sure the power of DVD/VCR has been turned off.
1
Press ON/STANDBY on the DVD/VCR and hold it until the
display shows rF:. The number next to rF: is the channel in
UHF-band to which you must tune your TV-set.
2
Switch your television to the program position on which the
video playback is seen. Start the channel search of your
television until "TEST" appears. Store this tuning in televi-
sion like also the case of the reception for normal televi-
sion-channels you would store.
If you want to use your DVD/VCR,
switch your television to this program
position.
3
If there is interference in the picture (you see 2 programs
simultaneously or what is called Ghosts), change the send-
ing channel in DVD/VCR. To do this, go back to the step 1.
Use CHANNEL button on the DVD/VCR to change the
number next to the rF:. Then return to step 2 and tune the
television newly.
4
Press ON/STANDBY on the DVD/VCR to turn off the
DVD/VCR.
TEST
VCR
1,4
3
TEST