Channel Setting - Toshiba RD-XV48DTKB Owner's Manual

E3NG1BD_EN.book Page 24 Monday, April 28, 2008 4:01 PM
Basic Setup
Initial Setting
When you turn on this unit for the first time, you need
to follow these steps.
1
Press [B ON\STANDBY].
2
Turn the TV on. Select the input to
which the unit is connected.
3
Select your desired channel preset
type using [U \ D]. Then press
[ENTER/OK].
Initial Setting
Auto Tuning
Make sure the antenna is
connected to "ANTENNA IN" jack.
Digital tuning
Digital & Analog tuning
Analog tuning
The unit will start getting channels available in
your area.
Digital tuning:
Only the DVB channels receivable in your area
are automatically scanned and memorised.
Digital & Analog tuning:
Both analogue and DVB channels receivable in
your area are scanned and memorised
automatically.
Analog tuning:
Only the analogue channels receivable in your
area are automatically scanned and memorised.
• If no channel has been memorised, the antenna
confirmation display will appear. Press [ENTER/OK]
to start auto scanning again or press [RETURN/
BACK] to cancel the initial settings.
4
After finishing channel setting,
"Clock Setting" will appear.
Clock Setting
01 / 01 / 2008
• The current date and time will appear
automatically.
• If the current date and time is correct, press
[RETURN/BACK] to exit.
• If you want to adjust the current date and time,
press [ENTER/OK] and follow to step
"Manual Clock Setting" on page 35.
24
EN
(TUE)
0 : 00
5
in

Channel Setting

You can retune this unit or edit the channel setting by
the following methods.
Auto Tuning (DVB & ANALOG)
Programme the tuner to scan both analogue and DVB
channels you can receive in your area.
1
In stop mode, press [SETUP]. Select
"General Setting" using [U \ D],
then press [ENTER/OK].
General Setting menu will appear.
2
Select "Channel" using [U \ D],
then press [ENTER/OK].
3
Select "Auto Tuning (DVB &
ANALOG)" using [U \ D], then press
[ENTER/OK].
The unit will start storing channels available in
your area.
General Setting
Playback
Auto Tuning (DVB & ANALOG)
Display
Video DVB Channel Setup
Recording ANALOG Channel Setup
Clock
Channel
DivX
HDMI
Reset All
Wait for several minutes to finish channel storing.
• Analogue channels will be stored in channel
901-999 after it is scanned by this unit.
4
Press [SETUP] to exit.
You can select only the channels memorised in
this unit by using [PROG. G \ H].
To cancel auto tuning
Press [RETURN/BACK] or [SETUP] during scanning.
Note
• The selection will be affected by how you receive TV
channels in your local area.
• If the auto tuning is cancelled during scanning,
some channels not yet tuned may not be received.
• You cannot change the channel when this unit is in
any recording mode (normal recording, One-touch
Timer Recording or timer recording).