Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for TC-Helicon MP-76
Summary of Contents for TC-Helicon MP-76
- Page 1 English Manual...
-
Page 2: Table Of Contents
About this manual Introduction Setup Using MP-76 with … VoiceLive 3 VoiceLive Touch 2 VoiceSolo FX150 Play Series product Technical specifications Getting support Product MP-76 Product (firmware) version Document English Manual Document version / date 2015-01-20 MP-76 English Manual – 2015-01-20... -
Page 3: Important Safety Instructions
12. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the ap- paratus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. MP-76 English Manual – 2015-01-20... -
Page 4: Emc/Emi
► ment and receiver. Connect the equipment into an outlet on a cir- ► cuit different from that to which the receiver is connected. ► Consult the dealer or an experienced radio/TV technician for help. MP-76 English Manual – 2015-01-20... -
Page 5: About This Manual
► Mic Control circuit with four buttons for con- both internal and external hyperlinks. For exam- With MP-76 and its four buttons, you can access trolling TC-Helicon vocal effects ple, clicking the TC-Helicon logo in the upper left a ton of aspects of your vocal processor without Rugged and ergonomic design ►... -
Page 6: Setup
Setup Setup Set… Connect your MP-76 to the next device in the ► Ready… signal chain using an XLR cable. The MP-76 box should contain the following ► You’re done! items: Cable recommendations MP-76 microphone ► ► Microphone clip Each MP-76 compatible product has slightly dif-... - Page 7 Helicon’s studio quality vocal processing from anywhere on stage. If the device supports the HIT feature, a “:” (co- lon) will be shown in the MP-76 LCD when HIT Mic Control has to be enabled via a switch or is ON.
-
Page 8: Using Mp-76 With
To deactivate the feature, press the button ► Large Control Knob. again”. ► Change the INPUT TYPE to MP-76 using the ► “Momentary” means: far Right Mix Knob (below the screen). “To activate the feature, press and hold button. To deactivate the feature, release the button”. -
Page 9: Voicelive Touch 2
To deactivate the feature, release the button”. ► button on the Matrix. Repeat this process for the other three mic ► ► Change the INPUT TYPE to MP-76 using the buttons (Left, Right, Down). SliderFX bar. You’re done! MP-76 English Manual – 2015-01-20... -
Page 10: Voicesolo Fx150
Since VoiceSolo FX150 has no presets, the dis- play will shows the level of Channel 2 instead. tc-helicon.com/products/voicesupport/ When Channel 2 is muted, the MP-76 display will flash and show the level as “0”. Ensure the +48V button on your VoiceSolo ►... -
Page 11: Play Series Product
To select what your MP-76 buttons do: Play Series product To enable Mic Control on your Play Acoustic, Press SETUP. ► Play Electric or VoiceLive Play for your MP-76: ► Navigate to the MIC CONTROL tab using the < or > arrow buttons. Press SETUP. -
Page 12: Technical Specifications
Weight: 0.63 lb. / 290 g ► Dimensions ► ► Height: 7.25 inches / 185 mm Diameter (max): 2 inches / 50 mm ► Due to continuous development, these speci- fications are subject to change without no- tice. MP-76 English Manual – 2015-01-20... - Page 13 MP-76 English Manual – 2015-01-20...
Need help?
Do you have a question about the MP-76 and is the answer not in the manual?
Questions and answers