Sony DAV-HDX277WC Operating Instructions Manual page 70

The system outputs the progressive signal
for 5 seconds. Check that the screen is
displayed correctly.
3
Press
+-1-+
to select [YES].
The system outputs the progressive signal.
If you select [NO], the system will not
output the progressive signal.
m:m'I
• [PROGRESSIVE (COMPONENT OUT)] is
effective only when you connect the unit and TV with
a component video cord (page 28).
• [4:3 OUTPUT]
When you use a 16:9 aspect ratio TV, you can
adjust the aspect ratio to watch 4:3 aspect ratio
signals. If you can change the aspect ratio on
your TV, change the setting on your TV, not the
system.
You cannot select this and the setting is not
effective when the system outputs progressive
signal.
[OFF]: You can set the black level of the output
signal to the standard level.
[ON]: You can raise the standard black level.
Use this when the picture becomes too black.
• [PAUSE MODE] (DVD VIDEO/DVD-RJ
DVD-RW only)
You can select the picture in pause mode.
[AUTO]: The picture, including subjects that
move dynamically, is output with no jitter.
Normally select this position.
[FRAME]: The picture, including subjects that
do not move dynamically, is output in high
resolution.
[FULL]: Select this when you can change the
aspect ratio on your TV.
[NORMAL]: Select this when you cannot
change the aspect ratio on your TV. A 16:9
aspect ratio signal with black bands on left and
right sides of the image appears.
16:9 aspect ratio TV
Settings f.r Ibe HilMI
[HDMI SETUP]
HDMI
SETUP
HDM! RESOLUTION:
CONTROL FOR
HD~I:
VOl,'.JME PMIT:
YGBGRlRGB{HOMI): .
AUOIO(!iDMI): ' .
JPE<lRESOLUTlON:; •
AUTO(l92Oxl080p)
.' OFF
LEVEL2
YGsGI'!
OFF
SOo
70
US
m:m'I
• [4:3 OUTPUT] is effective only when you set [TV
TYPE] in [VIDEO SETUP] to [16:9].
• [BLACK LEVEL]
You can select the black level (setup level) for
the video signals output from the jacks other
than COMPONENT VIDEO OUT/HDMI OUT.
[ON]: The standard level.
[OFF]: You can lower the standard black level.
Use this when the picture becomes too white.
• [BLACK LEVEL (COMPONENT OUT)]
You can select the black level (setup level) for
the video signals output from the
COMPONENT VIDEO OUT jacks.
• [HDMI RESOLUTION]
You can select the type of video signal that is
output from the HOMI OUT jack. For details,
see "To select the type of video signal output
from the HDMI OUT jack" (page 46).
[AUTO (1920 x 1080p)]: The system outputs
the optimal video signal for the connected TV.
[1920 x 1080i]: The system outputs 1920 x
1080i* video signals.
[1280 x 720p]: The system outputs 1280 x
720p* video signals.
[720 x 480p]**: The system outputs 720 x
480p* video signals.
*
i: interlace, p: progressive