Meap Safe Mode (Level 2); Starting In Safe Mode - Canon imageRUNNER ADVANCE C5045 Series Service Manual

2

MEAP Safe Mode (level 2)

Use safe mode if you need to start up the system without worrying about extra applications. It
will start up only those system software files (including SMS) that normally start up as default
files while preventing MEAP applications and the like from starting up.
When you have made changes and restart the device, the control panel will indicate 'MPSF'
in its lower right corner. The MEAP applications that may have been active before you shut
down the equipment will not start up on their own. Make use of safe mode when restoring
the system software as when MEAP applications or services cause a fault as the result of a
conflict or wrong sequence of registration/use. You can access to SMS in this condition so
that you can take necessary measures, for example, you can stop application that may cause
the trouble.
If default authentication has been selected, the mode of authentication remains valid;
otherwise, the message "The login service must be set again with SMS" ap pears. Change
the login service as necessary.

Starting in Safe Mode

1) Startup level 2 of [SERVICE MODE] . The start procedure of [SERVICE MODE] level2 is as
follows.
1. Press [Settings /Registration] button n control panel.
2. Press [2] button and [8] button at the same time on control panel.
3. Press [Settings /Registration] button.
4. [SERVICE MODE] screen is displayed.
5. Press [Settings /Registration] button.
6. Press [2] button.
2) Press [COPIER] >[Option] > [USER] buttons.
2
button for several times until [MEAPSAFE] button is shown. Click
3) Press or
[MEAPSAFE] button.
4) Press the 1 key on the control panel keypad to change the setting to '1'; then, click [OK]
button.
F-2-221 F-2-221
2-141
F-2-222 F-2-222
F-2-223 F-2-223
2-141