•Assemble and tighten the brass screw.
•To pierce the tubing, turn the Valve
Handle fully clockwise (inward). A small
amount of water may escape from the
outlet until you are fully pierced.
When you feel the Valve Handle firmly
seated in the clockwise direction, the copper
tube is pierced and the valve is closed.
2b. To install on (hard) Steel or Brass Tubing
supply line.
•The supply line should now be drained. Use a
battery powered or properly grounded drill to
avoid shock hazard.
3
•Drill a
/
" hole in the supply line; (do not
16
drill through the opposite wall).
•Turn the handle to expose the lance no more
3
than
/
" beyond the rubber gasket.
16
•Place the body of the valve over the hole so
that the lance fits into the hole.
•Assemble and tighten the brass screw.
•Turn the Valve Handle clockwise (inward)
until firmly seated. The valve is closed.
Drain Clamp
Insert
Compression
Nut
Black Drain
Tubing
3/8" DRAIN CLAMP ASSEMBLY
Drain Pipe
1/4" Screw
Front Plate
Figure 4
3. With the Feed Water Saddle Valve closed,
open the sink faucet and the water supply and
allow the water to run for a few minutes to
flush any debris caused by the installation.
•Close the faucet and check the Feed Water
Saddle Valve for leaks.
C. Drain Clamp Installation
Choose the drain outlet location per Sec. III, C.5,
page 5.
The following are instructions for discharging into
the sink drain pipe. (Refer to Fig. 1, page 1.)
1. Position the Drain Clamp on the sink drain
pipe above the drain trap. Allow room for
drilling. Tighten securely.
2. Use a battery powered or properly grounded
drill. Using the Clamp port as a drill guide,
7
drill a
/
" hole through the wall of the drain
32
pipe. Do NOT penetrate the opposite side of
the pipe.
3
3. Locate the
shipped loose in the box.
7
/
" Black Drain Tubing which is
8
1/4" Nut
Drain Clamp
Back Plate
Need help?
Do you have a question about the RayneClear and is the answer not in the manual?
Questions and answers