Filter Alarm - La Marzocco GB/5 Software Programming Manual

Technician Level Parameters
Filter
Alarm
e -
Description
• This parameter allows the technician to preprogram
an alarm that notifies the user when the water filter
requires service or replacement.
• When the programmed volume of water has passed
through the espresso machine the error message
"Change Filter" is displayed.
• A value of 0 (zero) disables the filter alarm
parameter.
Display
1
LaMarzocco 09:30
2
Password
?????
3
Language
English
4
Filter
Alarm
5
Change H2O Filt.
0 liters
6
Water Flow
12 cc/sec
7
32

Filter Alarm

Press and hold the button on the group 1 keypad until the following is displayed
(approximately 10 seconds):
Enter the 5 digit technician password using buttons 1-5 on the group 1 keypad. Once accepted the
following appears:
MODE
Press the button on the group 1 keypad until the following appears (about six times):
ENTER
Press the button on the group 1 keypad until the following appears (about six times):
+
Press the or the
replacing is recommended. When finished press
+
Press the or the
should not be changed. When the desired value is displayed press
When finished, continue to the next parameter or press
Note: To reset the function turn off the machine with
3 seconds). Next, press and hold the
Operating Procedure
button to change the volume of water required before filter servicing/
to confirm.
ENTER
button to change the estimated flow rate of water. Normally this value
ON
OFF
button while turning on using
MODE
Version 1.3
to confirm.
ENTER
ON
to exit programming mode.
OFF
the button (press and hold approximately
the button.
ON
OFF
La Marzocco, S.r.l. Firenze, Italia