Technical Information; Cause And Solution Of Problems - Clay Paky A.LEDA B-EYE K10 Instruction Manual

340
(13.39")
Zoom OUT
290
(11.42")
Zoom IN
230
(9.06")
Zoom OUT
180
(7.09")
Zoom IN
479
(18.86")
subject to change without prior notice
430
(16.93")
Zoom OUT
380
(14.96")
Zoom IN
250
(9.84")
Zoom OUT
200
(7.87")
Zoom IN
(23.19")
subject to change without prior notice
THE PROJECTOR WILL NOT SWITCH ON
ELECTRONICS NON-OPERATIONAL
DEFECTIVE PROJECTION
REDUCED LUMINOSITY
POSSIBLE CAUSES
No mains supply.
LED exhausted or defective.
Signal transmission cable faulty or disconnected.
Incorrect addressing.
Fault in the electronic circuits.
Lenses or reflector broken
Dust or grease deposited.
A.LEDA B EYE

TECHNICAL INFORMATION

248
(9.76")
423
(16.65")
253
(9.96")
370
(14.57")
476
(18.74")
589
395
(15.55")

CAUSE AND SOLUTION OF PROBLEMS

Power supplies available
100-240V 50/60Hz
Input power
• K20 - 750VA
• K10 - 450VA
LED source
LED Osram Ostar RGBW - 15W
Average LED life: 50.000 h
Motors
5 (k10), 7 (k20) stepper motors, operating with microsteps,
totally microprocessor controlled.
360
Cooling
(14.17")
• High efficiency die-cast aluminium
• Forced ventilation
Inputs
DMX 512
Working position
Functioning in any position.
Movable body
358
(14.09")
• Movement by means of two stepper motors, controlled by
microprocessor.
• Automatic repositioning of PAN and TILT after accidental
movement not controlled by control unit.
• Travel:
- PAN = 540°
- TILT = 210°
IP20 protection rating
• Protected against the entry of solid bodies larger than 12mm
(0.47").
• No protection against the entry of liquids.
CE Marking
Complies with the following European Directives
- 2006/95/EC (LVD)
- 2004/108/EC (EMC)
460 - 2011/65/EU (RoHS).
(18.11")
Weights
• K10: 14.5 kg
• K20: 21 kg
330
(12.99")
Check the power supply voltage.
Call an authorised technician.
Replace the cables.
Check addresses (see instructions).
Call an authorised technician.
Call an authorised technician.
Clean (see instructions).
17
CHECKS AND REMEDIES
PROBLEMS