Konica Minolta DiMAGE Z3 Software Install Manual
Camera firmware ver.1.03e
Hide thumbs
Also See for DiMAGE Z3:
- Instruction manual (124 pages) ,
- Instruction manual (124 pages) ,
- Instruction manual (124 pages)
Advertisement
KONICA MINOLTA SOFTWARE INSTALL GUIDE
www.konicaminolta.com
www.konicaminoltasupport.com
DiMAGE Z3 Camera Firmware Ver.1.03e
This section explains how to install DiMAGE Z3 firmware version 1.03e. (Firmware is software used
internally to control the camera.) Be sure to read through the following explanation before you
install the software. Do not turn the camera OFF during installation; doing so could damage the
CPU inside the camera.
Contents of update
To support 2GB SD memory card.
Target products
This firmware is for use only with the DiMAGE Z3 and cannot be used with other products.
If the firmware version is already Ver.1.03e, it is not necessary to update the firmware. (Check the
firmware version as shown below.)
Checking the camera firmware version
1.
Press the main switch to turn ON the camera.
2.
Press the menu button.
3.
Press the right key of the controller, select SETUP icon,
and press the center of the controller to display the
setup menu.
4.
Confirm that the section 1 menu tab is highlighted, and
press the macro mode button. A window will open to
indicate the firmware version.
5.
Check the version number of displayed on the LCD mon-
itor. If the version is Ver.1.02e or earlier, the camera must
be updated.
Press the central button of controller to close the version
number display.
Advertisement
Table of Contents
Related Manuals for Konica Minolta DiMAGE Z3
Summary of Contents for Konica Minolta DiMAGE Z3
- Page 1 To support 2GB SD memory card. Target products This firmware is for use only with the DiMAGE Z3 and cannot be used with other products. If the firmware version is already Ver.1.03e, it is not necessary to update the firmware. (Check the firmware version as shown below.)
- Page 2 Preparing the SD memory card for updating A downloaded file must be copied to a SD memory card in the camera. Before updating the cam- era, read the data-transfer section of the DiMAGE Z3 instruction manual to connect the camera to a computer.
- Page 3 2. Confirm that the file has been copied to the card using the computer. 3. Disconnect the camera from the computer or remove the SD memory card from the card reader. If you are using Windows Me, 2000 or XP, click the unplug-or-eject-hardware icon in the lower right-hand corner of the screen, wait until the safe-to remove-hardware window appears, then remove the SD memory card the card reader, or disconnect the USB cable from the camera.
Need help?
Do you have a question about the DiMAGE Z3 and is the answer not in the manual?
Questions and answers